How do I remove a Konica Minolta Bizhub 352 transfer belt?

Hi,

for reset belt unit you have to change one fuse.

You need a new 50-80 ma fuse.

Remove the belt from the machine, the fuse is in the left side of the belt, under the left handle.

Replace it with a good same fuse.

For detailed guide see the link below:





Konica Minolta Service Manual

WHAT EVER YOU DO DO NOT PLACE ANY PRESSURE ON THE FOUR LARGE SHAFTS THE TURN THE DRUMS

Pull out the Drum and Transfer belt section. then from the right side gently clean the three sensors that site across from the belt. all three have metal covers BE CAREFUL they also have tiny springs don't lose them. Just lift them and clean the sensors with a dry rag. AGAIN do not touch those large shafts. if the cleaning them does not work remove the assy. two screws one connector. Don't lose the screws. Also clean out the Transfer belts cleaning blade unit remove hard toner remove the assy. and disassamble. Then run the gamma procedure in 36 mode.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

1st from the front Open the door and removed all Imaging unit start from the black. 2nd from the left side when your facesing the c450 Open remove the waste box. 3rd from there you will see the transfer belt on both side of it you will see screw just under the transfer belt loose it. Slide the transfer belt toward you.

above the 4 drum units have to remove the 4 toners the 4 image units and the transfer belts is removed from the right side after removing a section of the duplexer on the right side door.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Tray four lift ! REMOVE THE EXTRA PAPER FROM TRAY ON THE LEFT SIDE not a storage area!!!! Then check behind the the draw remove the paper, worse case you have a burned out lift motor or board or both.

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Transfer belt on this model is removed via left and right side of the machine two screws on the right side remove then the belt is pulled from the left side

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

can not be reset .it has to be reset manualy by a technician or replacing the units...

if i remember right, open right door, remove 2 tbu lock scews, open left cover, remove waste box and then remove tbu

Please visit the site http://www.resetkit.eu
There you can find how to reset your fusing unit and transfer kit unit for almost all Konica Minolta MFP's and printers, Bizhub C252 included.
You don't need to replace it, you can just reset it and save a lot of money.

Reset your Toners and Imaging units for Minolta Bizhub and CF series.
http://www.chipreset.eu

Yes,

Remove Trasfert belt unit.

On the left handled remove one screw ( spring fixer) and remove right srew (over the belt / bar whit finger fixee).

Remove, on the left spring stoppage and metal handled.

Remove black little srew and take to hand fuse contact.

Change fuse (behind) with new identical fuse and reassembly.

It may be reset trasfert belt counter.

Sorry for my not good english.

Bye.