Question about Ovens

1 Answer

My oven wont turn off from the knob it keeps turning

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

You didn't say whether you have a gas or electric oven, or oven & stove. I'll assume you have a stove, just to cover all bases.

First, you should shut down the oven: a gas stove will have a valve on the gas line behind the stove. The valve will either have a red handle or a flat stem that usually has a hole in it. Turn either valve 1/4 turn to shut off gas, use a wrench on the flat stem. An electric stove should be shut off by flipping off the double circuit breaker for it in your electric panel. Do not unplug an electric stove when it is on; this can damage the plug &/or electrocute you.

Most likely the inside of the knob has stripped out. Look at the knob for a hole that has a setscrew in it: a small allen wrench or screwdriver will loosen the setscrew, most knobs don't have them and will pull off. Be careful to use even pressure on two sides of the knob; if you can't pull it off, use two butter knives or flat screw drivers to pry it up enough to get a grip on it.

Look at the center stem on the back of the knob, it will likely be cracked or stripped. Some stems have a D-shaped metal insert that strips out inside the plastic stem. If you have one, pull off a burner knob and compare the stems in the back, if they are the same size, put the burner knob on the shaft for the oven control, and use that knob to turn the oven control off.

If the burner knob won't fit, use your fingers or a pair of pliers (gently) to turn off the oven control shaft. If the shaft stops normally, you can turn the stove back on using either the gas valve or the circuit breaker. If you have a gas stove that doesn't have electric ignition (a clicking noise when you turn on a burner) you may need to re-light the pilots for the burners. Lift the covers off the burners to re-light the pilots.

If you have succeeded in turning off the oven, you need a new knob -- you can get one at an appliance parts store or maybe a hardware store. If the oven control did not turn off normally, I would leave the oven/stove turned off: the control itself will need to be replaced by a qualified repair person.

Posted on Mar 03, 2013

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
barkencoa
  • 3463 Answers

SOURCE: Is the knob that turn the light on repairable?

HI,and a merry Xmas.
Yes it is repairable, it is going to be one of two things.

1--the control knob is cracked or broken causing it to twist round without turning the control.
2--the spindle on the control is broken or loose inside the switch.
Pull the knob off, and see if yopu can turn the switch on and off with a pair of grips or pliers.
This way it will enable you tell if it is just the knob or the switch that is faulty.
Good luck.

Please leave feedback for my suggested solution.

Posted on Dec 25, 2009

  • 3 Answers

SOURCE: simpson wall oven 2001 wont turn off unless its turned to automatic.

Oven thermostat is faulty. needs replacing.

Posted on Feb 17, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My oven wont turn off


The thermostat for the fan is shorted out

Jan 28, 2016 | Ovens

1 Answer

Whirlpool generation 2000 wont reset after powercut. Just says STOP.


Turn left knob to dash mark then turn right knob on normally see if this works. Hope this helps.

Dec 31, 2013 | Whirlpool Ovens

1 Answer

My hotpoint single oven wont heat up.the light will only go on when i turn to knob to light on..but it doesnt come on when i turn the knob for oven on and it doesnt heat up...until yesterday it was working...


Hi there If everything else is working then it's probably the heating element They are not expensive to replace and can be fixed in less than an hr Hope this helps

Sep 25, 2013 | Hotpoint SY36 Style Line Stainless Steel...

1 Answer

What will make a oven come on with the oven knob turned to the off position?


Maybe your knob is turning but the rod the knob is connected to is not turning. Best to remove knob and turn the rod to off position with Pliers to be sure it is actually being turned to the off position.

Jan 15, 2018 | Frigidaire 30" Self-Cleaning Freestanding...

1 Answer

Simpson wall oven 2001 wont turn off unless its turned to automatic.


Oven thermostat is faulty. needs replacing.

Feb 17, 2012 | Ovens

1 Answer

How can you fix the oven it wont heat


Turn the knob because that's when gas will be coming out but of course you cant see it. Then put a sparkler, lighter, or match right above or near the burner. That should keep it going for now until it gets fixed.

Jan 05, 2012 | Ovens

1 Answer

Oven wont turn on


I have a delongi oven and hob hob is working fine but the oven isnot im turning the nob on the front of the oven and ignition on lighting is fine after I release the knob on the front the supply turns striaght off no flame no gas nothing

Apr 04, 2011 | DeLonghi Ovens

1 Answer

Its an older model.When i cleaned it imoved the timer and manual knobs now oven wont work .thanks for your help


Turn oven on bake. Now turn the stop knob on the clock till it pops out. This should take care of the problem.

Feb 02, 2010 | Ovens

1 Answer

Knob on oven is not working properly


The knob is probably cracked, if you can pull it off, then you can try to see if you can turn the oven off with a pair of grips or pliers, if you can, then you just need to replace the knob, if not then you will have have to replace the switch.

Feb 01, 2010 | GE Ovens

1 Answer

Is the knob that turn the light on repairable? The oven light is on but would not turn off. The knob just keeps turning...


HI,and a merry Xmas.
Yes it is repairable, it is going to be one of two things.

1--the control knob is cracked or broken causing it to twist round without turning the control.
2--the spindle on the control is broken or loose inside the switch.
Pull the knob off, and see if yopu can turn the switch on and off with a pair of grips or pliers.
This way it will enable you tell if it is just the knob or the switch that is faulty.
Good luck.

Please leave feedback for my suggested solution.

Dec 25, 2009 | DeLonghi Ovens

Not finding what you are looking for?
Ovens Logo

Related Topics:

2,350 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ovens Experts

Marvin
Marvin

Level 3 Expert

85161 Answers

Craig Butler
Craig Butler

Level 3 Expert

1730 Answers

Brad Brown

Level 3 Expert

18072 Answers

Are you an Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...