Problem with a kipor 12 ta generator

190.3 volts isn't enough output for a 230 / 240 volt generator. It is protecting electronics that may be connected.

Specs show
Voltage (V) 115/230 120/240
https://www.google.com/search?q=L.H.+Propect+message%3F+Kipor+KDE6700TA+diesel+generator

..

Hi,

Usually when errors come up, you can reference the product manual to find out the specific meaning of your error. So, please do this first. If you don't have the manual, please call the manufacturer of your product (ie Kipor) in order to gain information of the meaning. In the mean time, I would advise to shut down the generator or at least use a air volatility detector until you determine the meaning of the error.

Thank you.

If you need to purchase diesel generator set, please visit at www.dieselgeneratortech.com

P01 oil pressure alarm
P02 frequency alarm
P03 voltage alarm
P04 unit overload alarm
P05 start-up fault alarm
P06 emergency shutdown alarm
P07 charging fault alarm
P08 unit overheating alarm PRE-H unit preheating instruction START unit start-up instruction.

Cummins generator and Perkins generator at website: www.dieselgeneratortech.com. power range is 20kw to 3000kw.

I would try disconnecting the oil pressure sensor temporarily to isolate that circuit as the possible cause of it shutting down.

Dear my friend, where the Kipor generator do you buy? Maybe you can contact your supplier, they should know for your question. In generally, there is after-sales ervice .
More support, maybe you can visit website for reference: www.dieselgeneratortech.com

Read the instruction manual. If you are certain you did everything right and the generator does not behave as intended then return it to the supplier as faulty.

hey take a look at this. i have some gen experience but. not seen one of these. YET kipor kde 6700 ta diesel generator troubleshooting repair coads

Start with the obvious first. Remove and clean your battery terminals and wire connections. Before you reconnect the battery, check your battery voltage across the +/- terminals with a meter. It should read 12 to 12.6 VDC. If it reads less than 11 volts, replace the battery. If the battery is good and the battery connections are clean & tight, you may have a faulty starter or a starter relay.

looks very similar to the kde 6700 ta