Canon IP3000 error code

Question 1

0helpful

3answers

Flashing orange light

Cannon pixma 3500 Flashing orange light count the blinks for the error,

Mar 17, 2014 • Canon PIXMA iP3500 Printer

10helpful

2answers

5 yellow blinks and nobody else ,

Issue: Alarm / Power light flashes orange 5 times consecutively (Print Head / Cartridge Error)
Solution: Reseat the print head iP3000

Reseat the print head

Confirm that the printer is powered on.
Open the paper output tray and top cover.

Note: Gently open the paper output tray while holding it.
After confirming that the print head holder has moved to the center, open the inner cover.
Remove all ink tanks
.Raise the print head lock lever and remove the print head.Re-seat the print head into the print head holder and lower the print head lock lever until a click is heard.Insert the appropriate ink tank into the slot at the right end and push down on the PUSH mark on top of the ink tank until a click is heard. Install the other ink tanks in the same manner.Close the inner cover and top cover.Properly installed: Note: Check that each ink tank is installed in the correct position

Issue: Alarm / Power light flashes orange 5 times consecutively (Print Head / Cartridge Error)
Solution: 2 Reset the printer

Resetting the Printer By resetting the printer's power, the print buffer is cleared and certain sensors are reset. If there is invalid data in the buffer, or sensors are stuck in a particular mode; errors may occur. Follow these steps to reset the printer:

Turn the printer off with the Power button (if available).
Disconnect the data cable from the printer (not applicable to WiFi, Bluetooth or Infrared) .
Unplug the printer's power cord for approximately 10 minutes, and then plug it back in. If troubleshooting a communication issue, reconnect the data cable (not applicable to WiFi, Bluetooth or Infrared).
Turn the printer back on.

Aug 30, 2011 • Canon PIXMA iP3000 InkJet Photo Printer

0helpful

1answer

Hi, The orange light in my canon ip1600 printer is blinking 5 times and green light once alternatively. Please give me a solution to fix it. What is the reason behind this problem? Thanks.

Probably your waste ink counter. Should be cleaned or replaced before resetting but usually you can get away with resetting once.
1. Start with printer OFF
2. Hold down RESUME and then hold down POWER
3. Release RESUME
4. press RESUME twice, then release POWER
5. let green light blink until printhead has finished moving.
6. Select functions below with RESUME, execute with POWER

0 presses - green light - Test Print (exit service for i960)
1 press - orange light - EEPROM info print
2 presses - green light - EEPROM initialise
3 presses - orange light - reset waste ink counter.

Jun 25, 2011 • Office Equipment & Supplies

0helpful

1answer

This is my problem: (Canon Pixma 3000) -5 flashes amber means the print head is not installed properly (error code 1401) or the EEPROM data of the print head is faulty (error code 1403 or 1405). Make...

you need to replace the print head,if you enter to the service mode not solve the problem with the prin head.

Feb 28, 2011 • Canon PIXMA iP3000 InkJet Photo Printer

2helpful

2answers

Canon IP3000 fault

Here are a couple of documents related to your problem (appears to be a print head error);

Error code synopsis;

www.decopac.com/resources/PDFs/iP3000%20Error%20Codes.pdf

Full product manual;

www.soft-manufaktura.ru/manual/hp/iP3000sm.pdf

Doesnt look terminal, at worst may need to replace the Print Head.

Hope this helps.

Dec 09, 2009 • Canon PIXMA iP3000 InkJet Photo Printer

1helpful

1answer

Printer not working. The light flashes red six times.

Error Condition Indicator Beeps Error
Code Possible Solution Paper Feed / Delivery Orange 2 Remove any paper jammed Paper Jam Orange 3 Remove any paper jammed Ink Out Orange 4 Add Ink BJ Cartridge Misinstalled Orange 5 Re-install cartridge or replace it NO BJ Cartridge Orange 6 Re-install cartridge or replace it BJ Cartridge Error Orange 7 Re-install cartridge or replace it Waste Full warning Orange 8 Waste is almost full , needs service very soon Service Errors Blinks Beeps Error
Code Possible Solution ROM Error 1 x Orange 10 6100 Try unplugging Printer RAM Error 2 x Orange 10 6300 Try unplugging Printer EEPROM 3 x Orange 10 6800 Try unplugging Printer Home Position 4 x Orange 10 5100 Temperature Sensor 5 x Orange 10 5400 Try unplugging Printer Waste Full 6 x Orange 10 5B00 Needs Service Cartridge OverHeat 7 x Orange 10 5200 Replace the BJ Cartridge(Printhead) Cartridge OverHeat 8 x Orange 10 5200 Replace the BJ Cartridge(Printhead) Cartridge Displaced 9 x Orange 10 5200 Replace the BJ Cartridge(Printhead) or reinstall Cartridge Displaced 10 x Orange 10 5200 Replace the BJ Cartridge(Printhead) or reinstall Cartridge Displaced 11 x Orange 10 5200 Replace the BJ Cartridge(Printhead) or reinstall Other Hardware error 12 x Orange 10 6500 Other Hardware error None None 5910 Needs Service Other Hardware error None None 5C00 Needs Service

Oct 01, 2009 • Canon S400 InkJet Printer

1helpful

2answers

The printer flashes orange light five times, and green once

Probably your waste ink counter. Should be cleaned or replaced before resetting but usually you can get away with resetting once.
1. Start with printer OFF
2. Hold down RESUME and then hold down POWER
3. Release RESUME
4. press RESUME twice, then release POWER
5. let green light blink until printhead has finished moving.
6. Select functions below with RESUME, execute with POWER

0 presses - green light - Test Print (exit service for i960)
1 press - orange light - EEPROM info print
2 presses - green light - EEPROM initialise
3 presses - orange light - reset waste ink counter.

This also applies to the i550, i560, i950, i960

Sep 07, 2009 • Canon BubbleJet i560 InkJet Printer

0helpful

1answer

My ink cartridges wont are stuck. They will not move at all. I try to print documents and it just says printer has an error. On the screen of the printer it shows E and 5 blinking and the alarm light is...

If the orange light is blinking 5 times then the error is:

[From the service manual]
The print head is not installed [1401], or it is not
properly installed (EEPROM data of the print
head is faulty) [1403 / 1405].

I'm guessing that you've been using this printer and printhead for a while though so it's more likely that the printhead is dead and you need to purchase a new one.

Depending on where you are in the world, getting a new one is pretty simple but costs vary.

In the USA, buy direct from Canon and you'll get it pretty cheap.. Unfortunately elsewhere, like the UK, you have to pay more than the printer is worth to get a new one which is frustrating.

Hope that helps.

Jan 26, 2009 • Canon PIXMA iP4000 InkJet Photo Printer

0helpful

1answer

Canon i950 won't print

try this Probably your waste ink counter. Should be cleaned or replaced before resetting but usually you can get away with resetting once.
1. Start with printer OFF
2. Hold down RESUME and then hold down POWER
3. Release RESUME
4. press RESUME twice, then release POWER
5. let green light blink until printhead has finished moving.
6. Select functions below with RESUME, execute with POWER

0 presses - green light - Test Print (exit service for i960)
1 press - orange light - EEPROM info print
2 presses - green light - EEPROM initialise
3 presses - orange light - reset waste ink counter.

one by one

Jan 25, 2009 • Canon i9900 InkJet Photo Printer

0helpful

2answers

5 flashes amber pixma ip3000 5 AMBER FLASHES PIXMA IP 3000

Try this link http://www.fixyourownprinter.com/forums/inkjet/27412

Stanr

Oct 02, 2008 • Canon PIXMA iP3000 InkJet Photo Printer

Question 2

Anonymous

Contributor 13 Answers
Posted on Feb 21, 2009

Anonymous

Contributor

Joined: Feb 21, 2009

Answers

13

Questions

0

Helped

9068

Points

29

read entire solution first, see the 6 modes section.
First thing you need to do is print an EEPROM information page, step number 2 below.
Once you have an EEPROM print you can reset the waste ink counter, if needed, which is step number 4 below.
Service Mode: This printer has a service mode for service-related settings and for performing test prints. The operator panel buttons are used to enter the desired service mode.
Service Mode Operations
With the printer powered off, hold down the "Resume Button" and press the "Power Button".

While holding down the "Power Button", release the Resume Button" and press the "Resume Button" twice in succession. Now release the "Power Button".

The indicator will blink in green and remain lit in green.

Select one of the following service mode functions by pressing the “Resume Button” the specified number of times.

1 time = Service test print.
2 times = EEPROM information print.
3 times = EEPROM initialization
4 times = Waste ink counter resetting
5 times = Destination settings
6 times = Print head deep cleaning

Then press the “Power Button” one time to perform selected function.

If you press the "Power Button" two times it will take you out of service mode.

This information is listed above in this thread and many times in other Canon threads in this forum. I simplified Canons wording so I could remember the service mode functions easier.

I got service error 5100 after a paper jam sometimes 5 times blinking orange. in my PIXMA IP 3000

to fix it
1. Turn off printer
2. Hold down Resume button and press Power button.
3. Keep holding down Power button and let Resume button go.
4. Press Resume button 2 times then let BOTH buttons go.
5. Green lights will flash and then stop blinking.
6. When green lights are solid, press the Resume button 4 times.
7. Press the Power button and the printer should turn off, if not,
press the Power button once more.
8. Your printer should respond as normal..

or: and Also;
Unplug unit, hold power and reset button down then plug it in while still holding both buttons down;
Then to step 3 above.

Answer 2

Morgan Kane

Contributor 16 Answers
Posted on Jun 23, 2012

Morgan Kane

Contributor

Joined: Oct 15, 2008

Answers

16

Questions

4

Helped

6144

Points

44

I have tried to follow all advices here to restet my IP3000, 5 orange flas, one green, but it does not work.
After done step for, the green light NEVER stop blinking. Instead the orange flashes comes back as ususal. I have tested this several times now, and I am used to do service at printers.
There must be an error in the description, OR my printhead is too much damaged.
A new one is more expencive than a printer, but I have ink in stock :-(

Related Topics:

Canon IP3000 error code

2 Answers

Anonymous

Morgan Kane

Add Your Answer

Attachments: Added items

Related Questions:

Flashing orange light

5 yellow blinks and nobody else ,

Hi, The orange light in my canon ip1600 printer is blinking 5 times and green light once alternatively. Please give me a solution to fix it. What is the reason behind this problem? Thanks.

This is my problem: (Canon Pixma 3000) -5 flashes amber means the print head is not installed properly (error code 1401) or the EEPROM data of the print head is faulty (error code 1403 or 1405). Make...

Canon IP3000 fault

Printer not working. The light flashes red six times.

The printer flashes orange light five times, and green once

My ink cartridges wont are stuck. They will not move at all. I try to print documents and it just says printer has an error. On the screen of the printer it shows E and 5 blinking and the alarm light is...

Canon i950 won't print

5 flashes amber pixma ip3000 5 AMBER FLASHES PIXMA IP 3000

Not finding what you are looking for?

PIXMA iP3000 InkJet Photo Printer

Flashing orange light

Ask a Question

Check Out the Latest Printers Report

Top Canon Office Equipment & Supplies Experts

old marine

ZJ Limited

Cindy Wells

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Manuals & User Guides

Related Topics:

Canon IP3000 error code

2 Answers

Anonymous

Morgan Kane

Add Your Answer

Attachments: Added items

Related Questions:

Flashing orange light

5 yellow blinks and nobody else ,

Hi, The orange light in my canon ip1600 printer is blinking 5 times and green light once alternatively. Please give me a solution to fix it. What is the reason behind this problem? Thanks.

This is my problem: (Canon Pixma 3000) -5 flashes amber means the print head is not installed properly (error code 1401) or the EEPROM data of the print head is faulty (error code 1403 or 1405). Make...

Canon IP3000 fault

Printer not working. The light flashes red six times.

The printer flashes orange light five times, and green once

My ink cartridges wont are stuck. They will not move at all. I try to print documents and it just says printer has an error. On the screen of the printer it shows E and 5 blinking and the alarm light is...

Canon i950 won't print

5 flashes amber pixma ip3000 5 AMBER FLASHES PIXMA IP 3000

Not finding what you are looking for?

PIXMA iP3000 InkJet Photo Printer

Flashing orange light

Related Topics

Ask a Question

Popular Questions

Error code E31 scanning with Canon MP495

Aborber full error message

Error: The type of Printhead is incorrect, Install the correct printhead.

Reset ink level on CANON MP 140 PIXMA PRINTER

Canon PIXMA MP190 reset ink?????

Check Out the Latest Printers Report

Top Canon Office Equipment & Supplies Experts

old marine

ZJ Limited

Cindy Wells

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Manuals & User Guides