Need to replace impeler on flotec pump - Flotec 1 - 1/2 Sprinkler Pump Composite Quick Priming High - Capacity 115/230v

Ohhhh ya. Fun, fun, fun. But, there is a way. Watch this video from Joseph and Robert on the "easy way' to remove a stuck water pump impeller.
How To Remove Stubborn Impellers

All you have to do is remove the back cover loosen up the gray contact and hold the shaft with a 7/16 wrench. Scroll down on this website and follow pics. Good luck.
http://www.troublefreepool.com/is-this-impeller-broken-t22383-20.html
Tony

I believe you can find it at this website.
http://www.pumpagents.com/JabscoPumps/Jabsco-Impeller-Guide.html

Good luck
RJ

Same pump, same problem. H/D sells the pumps, but no parts. Here's a link to a vendor of Flotec parts. http://www.pumpvendor.com/Flotec_Parts_List.html

The impeller screws on the motor shaft. First replace the through bolts in the motor. These are the long bolts, they will just cause headachs. On the back of the motor their will be a place to hold the shaft from turning, If you hold the shaft the impeller just unscrews. If you look in the center of the impeller it may have a set screw holding it to the shaft. If you have one of these it will be a left hand screw. Then you will need to break the impeller free as the brass that holds the impeller on will stick to the stainless steel of the shaft. Don't let how tight this is fool you when you put this back together it just goes on hand tight. Good luck

Clogged, Impeller loose and not turning. Remove strainer from bottom of pump and check for clogg and see if the impeller is turning.

Try to match it to sta-rite PLBC

you would have to contact flotec----there should be a part for it,, depending on the age of it, they change the covers all the time to get people to have to replace the whole unit

WW Graingers. Call them with model and serial #s. If you do not have an account with WW, These guys have what ever you need:
http://www.pumpagents.com/partpages/FlotecPumps/FP4012.html