It worked fine 2 days ago. Can I adjust the screws in back to make it start.
There is only one adjuster screw in the back of the unit.most likely your problem is in the rotor.you need to take the back plate off then you should see 6 more screws on the metal plate.remove them to get to rotor.the air vains should drop to the bottem without any help.usualy they pick up moisture for the air from sitting.pull the out and soak them in lacquare thinner for a few minutes then wipe them off with a paper towel.install them one at a time and check to see if they drop or not,if they don't i use a piece of 280 grit sand paper and carefully sand the marks off them.don't get to carried away though.sand a little then try them.once you get them to drop by them self reinstall the cover and try to ignite the unit again.
Hi,
Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater...
Reddy Heater - Troubleshooting Torpedo Heaters
Torpedo Heater Pump Pressure Adjustment
heatman101
Hi,
Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater...
Reddy Heater - Troubleshooting Torpedo Heaters
Torpedo Heater Pump Pressure Adjustment
heatman101
,./,./
Hi,
Here are a couple of tips that I
wrote that tell you how to troubleshoot a Torpedo or Reddy
heater...
Reddy
Heater - Troubleshooting Torpedo Heaters
Torpedo
Heater Pump Pressure Adjustment
heatman101
/;/;/;/;/;/;/;/;/;/;/;/;/;/;/;/;/;/;
361 views
Usually answered in minutes!
×