I dont no where the filter is back ,front or some where else

.will look the size of a can of soup

try under the back near the fuel tank
or under the front of the jag .

usually requires a special fuel filter removal tool
note real men dont use correct tools


front


rear near tank

take it back to teh garage and ask them nicely if they can have a look for you ,dont shout or scream but be firm and dont pay for the extra if they ask for it

hi, read about your problem. The filter is located at the bottom of the front of washer. If its not visible, remove the bottom kick panel. Three screws at bottom. Take a shallow pan and place under filter. Slowly turn counterclockwise and water will slowly start to come out. When pan is partially full, empty. Be sure to close filter before doing this. Keep up with this procedure until no more water comes out, then unscrew filter and remove and clean. Reinstall and put kickplate back on. Hope this helps.

I have had this washer and it has been a nightmare since day one... the problem is that your filter (catch basin is clogged) you have to unscrew the front of the bottom of the machine and you will see a round lint trap. make sure you have a bucket in front of you and beware it smells really bad... unscrew that and your golden-- dont even bother to put the front panel back on-- we have to clean our filter monthly.. good luck

fuel filter should be by the left back wheel or whichever side the petrol cap may be. follow the fuel line from the engine towards the back and you should see it. a big steel black filter. good luck

the filter is at the front of unit at the bottom behind plastic panel. if u have a manual it will show u where it is. if u dont tr y LG web site they are very helpfull. if u r still uncertain, reply back and i help u more.

There must be something stuck in the filter, as normally it should pull straight out once you have unscrewed it.
Try screwing and unscrewing it at the same time keep twisting and pulling at the filter.
If you can't tremove it, then you sre going to have to remove the complete pump in order to clear the obstruction
Hope this helps you ..

I have a vrt ... I hope this helps.... Take of that little door on the front. Have a bucket or bowl ready. Bring down that little black hose, turn the white cap around and pull till it comes off. Drain into the bowl, turn the white filter cap counter clockwise to release some of the suction and wait till the hose stops draining. Remove cap, clean under running water w/ toothbrush. Manual says to make sure that the interior is free of anything (I wiped mine out) and then put it all back together again. Good luck

Below is for Whirlpool/Kenmore, u might find it helpful. Some machines have a small trap door on left front bottom, coin trap.

The filter on your pump is probably clogged with lint and stuff. You have to remove the bottom front panel, 3 torx screws underneath. The panel will drop and come off. Drain off the excess water from the drain pipe you see. The white filter cover is right in front. Get yourself a good plastic bag to collect water. Unscrew the filter cover and twist the filter out. Clean out all the stuff and put it back in carefully. Check your pump too.

On some models the filter is located ‘inside’ the big hose from the bottom of the tub. This takes more time to clean.

front loader filters are at the bottom use a screwdriver to remove it may be stuck full of coins.also make sure you dont have a button pressed in by mistake.hope this helps you