I have a 5 year old + Dishlex ''Eco'' Global 300 dishwasher. During the last cycle ''Eco'' was continuously flashing with the pump motor running continuously.
The manual says for this problem ''incorrect fill level or fill time'' - Contact service division.
Can this be fixed wihout contacting a service division?
Hi
soyunds like it flooded the base
You need to dry out the base of the machine thoroughly and it should re set
I found a small silver seal what they use before they put the bottle cap on in under the filter era clean it out properly and run a couple of cycles to see if the water is draining freely the lights are flashing to say something is wrong and to save the pump mine is running good now I hope this helps dave
1,446 views
Usually answered in minutes!
I needed to dry out the overflow tray on the bottom of the dishwater and ensure that the float was reset so that it was again on the bottom of the tray.
Note: Unit disconnected from the powerpoint first. Overflow tray located behind the metal access panel under the door behind the kick panel.
to get the dishwasher going with a faulty overflow switch I just pulled the blue wire off the overflow switch and the dishwasher worked . This is only a temporary measure of course and I had to replace the float switch but it got me out of trouble.
×