Ok my amana ptac wont stop blowing air until i push the off button. I put the temperature at 66 and it wont stop blowing, i waited all day to turn off and it didnt. Do i put a certain setting? if i do, how? Thanks
SOURCE: I have an Amana ptac hotel type thru the wall
Hi,
If you reset the GFCI button and then when you go to turn it on the button pops again, then you have a short inside the units probably in the fan motor or the compressor..
heatman101
SOURCE: amana ptac shuts on and off constantly
your control board is shot and your ac can't tell the room is cold enough. 1-888-855-9987
SOURCE: amana ptac- blows same temperature air whether its
Check to see if your compressor is running. Thre are 5/16 screws on either side of the unit holding it to the case. Take those out and you can get to the cpmpressor. These are not complicated units but you may have to have a service tech look at it for you. I do sell a lot of these PTAC units so if your compressor is running you have leak or bad compressor. Russ
SOURCE: I have thru-wall PTAC Amana PTH093B35AM unit. I
see if you can find a new board the power failure fried it
785 views
Usually answered in minutes!
×