Need manual would like to know the policy an procedure manual for the kettle as well as the safty hazards manual Thank you

Without knowing the model, I can only give you a general procedure to follow if you have a meter with volt / ohms reading. Unplug the cord and check it for continuity with your ohm-meter so you are certain that power is getting to the unit's plug. Use your ohm meter to check for continuity with resistance between the kettle's plugs.

You can't, there is no adjustment provided for.

Mrs Nagy, they do not make things like they use to, it is getting quite common for small appliance to break down after one year, you would almost swear it is built into them to garnade after warranty is up.
the most common problem, the electric cord itself breaks either at the plug or at the entry point at base of kettle, do a wiggle test on the wire to see if it makes a contact, just be careful of a shock hazard, do not do this if you see any bare wire at all.
press the helpful button,

instructions - Russell Hobbs

uk.russellhobbs.com/pdf/14590_stylis_black_kettle.pdf

2 Don't put the kettle, stand, cable, or plug in liquid. ... 4 Don't open the lid while the water is heating. 5 Don't ... 8 Put the kettle on the stand - take care not to spill. .... To avoid environmental and health problems due to hazardous substances in electricaland electronic goods, appliances marked with this symbol mustn't be.Missing: code

Kettles - Russell Hobbs

en.russellhobbs.com > Our Products

Over the decades, Russell Hobbs has been at the forefront of quenching our national thirst for hot beverages with fast, easy to use, great looking electric kettles.Missing: open ‎question ‎enter ‎code

Russell Hobbs KE9000S Electric Kettle, Stainless Steel

www.amazon.com/Russell-Hobbs...Electric.../B00A15...

Amazon.com, Inc.Amazon.com: Russell Hobbs KE9000S Electric Kettle, Stainless Steel: Electric ...

Fixya does not sell or warrant timers
Copy following link to identify Timex timer.
http://waterheatertimer.org/Woods-timers-and-manuals.html#Timex
Timex does not show timers on their website, and unknown who carries warranty for this line of timers.
If you want clear warranty coverage, I suggest Intermatic timers, and Woods timers, or Sylvania, Leviton.
Each of these brands has clear warranty procedure shown on website for each.
Add a comment for more specifics

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Farberware manuals do not seem to be available online. Try contacting Farberware Customer Service at the following site:



http://www.farberware.com/customerservice.html?hm=Y&ct=N&anw=N



For electric kettles try the e-mail address for Electric appliances. Send your model number with your request for a manual.



Thank you for using FixYa!

there may ber a recall on this problem, it is caused by the turn sigfnal/hazard flasher combination switch relay in the dash, check with the dealer 1st on the recall to see if it applies if not then u will need to replace the flasher unit in the dash, the switch is part of the hazard button and is located behind the ceter panel of the dash here is the whole recall.

2002 CHEVROLET MALIBU -- In December 2004, GM issued a special policy for MY 1999-2000 Alero, Grand Am and Malibu vehicles not covered under recall 03V327. The policy covered turn signal/hazard flasher failure for a period of 10 years or 150,000 miles (whichever occurred first) to provide a no cost replacement of the hazard switch. GM sent letters to owners starting December 30, 2004. In January 2006, GM will update the special policy to include MY 2002 Alero, Grand Am and Malibu vehicles not covered under recall 03V-327. The policy covers turn signal/hazard flasher failure for a period of 10 years or 150,000 miles (whichever occurs first) to provide a no cost replacement of the hazard switch. GM will send letters to owners starting late April 2006. The actions taken by the manufacturer is sufficient to resolve the issues raised by this investigation. The closing of this investigation does not constitute a finding by NHTSA that no safety-related defect exists. The Agency reserves the right to take future action if warranted by the circumstances. Investigation was initiated on September 27 2005. Closed on January 13 2006. For detailed information & supporting documents, see the official NHTSA page concerning investigation #PE05055 »

Get one at Best Buy; get the 2 year service policy for 8 bucks. Set an akarm on some computer/PDA thing for 102 weeks away. If, by some miracle, the thing lasts that long, bring it back and get a (free) new one. Oh, get the policy on the new one as well!

Check out this recall below:
Bulletin No.: 04098A

SPECIAL POLICY
Subject:
04098 - Special Policy Adjustment - Turn Signal/Hazard Warning Flashers 

Condition
Some customers of 1999-2002 Chevrolet Malibu, Oldsmobile Alero, Pontiac Grand Am, and 1999 Oldsmobile Cutlass may have turn signal/hazard flashers that become inoperative.

Special Policy Adjustment
This special policy covers the condition described above for a period of 10 years or 150,000 miles (240,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership. The repairs will be made at no charge to the customer.

Good luck and hope this helps:
HAZARD WARNING SWITCH REPLACEMENT - ON VEHICLE 
REMOVAL PROCEDURE 

Remove the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent. 
Remove the instrument panel cluster. 
Remove the hazard warning switch bezel from the instrument panel using a small-flat bladed tool to release the retainers.
Remove the left side bolt from the hazard warning switch through the instrument panel cluster pocket Remove the right side and center lower bolts from the hazard warning switch through the center air louver deflector pocket.
Reposition the hazard warning switch from the instrument panel to access the electrical connector. 
Disconnect the electrical connectors from the hazard warning switch. 
Remove the hazard warning switch from instrument panel. 

INSTALLATION PROCEDURE
Connect the electrical connectors to the hazard warning switch.
Position the hazard warning switch to the mounting points in the instrument panel. NOTE: Refer to Fastener Notice in Service Precautions.
Install the left side bolt to the hazard warning switch through the instrument panel cluster pocket. Tighten Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in) . 
Install the right side and center lower bolts to the hazard warning switch through the center air louver deflector pocket. Tighten Tighten the left side hazard warning switch bolt to 3 N.m (27 lb in) . 
Install the hazard warning switch bezel to the instrument panel pressing into place until fully seated. Install the instrument panel cluster. 
Install the center air louver deflector. Refer to Air Deflector Louver Replacement - Center Vent.

ALERT :- Tefal Quick Cup can TURN IT SELF ON. Tefal know about this but it is a potential fire hazard. Mine turned itself on and dispensed the water reservoir over my kitchen. Dread to think if I had been out shopping what could have happened. Tefal know about this problem but are not doing anything to advertise the fault!!