Need to set up clock on microwave

Touch clear, clock, enter time then press the clock button.

Disconnect the microwave from the power source while the power is still out. If the microwave is a built-in, turn off the circuit breaker. Otherwise, unplug the microwave from the wall outlet. This prevents a power surge from damaging the magnetron tube when the power is restored.Turn on the circuit breaker or plug the microwave into the outlet only when you are sure that the power is permanently restored. If there are still storms in the area, the power may be disrupted again. Reset the clock on the microwave. Microwaves vary slightly on how to set the clock, but usually there is a clock button you press. Use the number pad to input the correct time and press the clock button again to set it. Test the microwave by heating some water to ensure that it is still in good operating condition.

usually you push clock, put in time, push clock, click am/pm to whichever it is, then push clock again. That should set it.

It depends on the make/model of the set.
All you need is to press and hold and the clock will blink on the hour/minutes and it must be changed and set. Use the button marked clock to press to hold for setting. Change time using the 0-9 key pads by typing the correct time..

hello there:
to set the time on you're micro wave you will need to push the clock button and use you're number pad to enter the time and once you have got the time set properly you will need to press the clock button again.... hope this helps you out sincerely D.Jones

normally you look for the clock ot watch icon. Pressing it once will give you the option for 24 hours setting. Press it twice and it will give you the opportunity to set to 12 hours setting. Using the no. keypad, punch in the time and then repress the clock icon again.

To set the time just press CLOCK, then press CANCEL, then enter new time setting and press CLOCK again.

You may need to open and close the door first.

Press CLOCK > 1 > 2 > 3 > CLOCK.

Let us know if this doesn;t work. You may have a bad door switch or mount.

The easiest way I can remember is to turn off the power, then back on... this will make the display flash, then press stop/clear.

Then press clock, enter the time eg: for 9 am or pm enter 9.00 and press clock again.

Hope this helps.

I have this model. Press clear then press Auto/Clock. Enter in the time eg 700 then press Auto/Clock again. The time should now be set