Can this camera be RESET? Camera Stuck in Clock set mode.

Time Zone Setting

1. Press the MODE button to enter the Alarm Time Mode.
2. Press the SET button to change the time zone.
3. Press the MODE button to exit.

One button of the camera is stuck, try pressing hard all buttons various times with the camera turned off and try using it again.

Press and hold the shooting mode button (to the right of the display panel on top, marked with overlapping rectangles) and turn the command dial on the back to change shooting modes. The self-timer is the one with a one-handed clock. (And just the one-handed clock. Don't select the one with the one-handed clock and a rectangle representing the remote control.)

The date stamp feature on this camera will only work in postcard mode- resolution set to 2M (1600 x 1200) and compression set to fine. You have to set the picture mode to that first. You also have to set the date and time if it isn't set already.

To set the mode quickly, set the mode switch to camera, turn the mode dial to A (auto), then press Func. button, scroll down to the "L", scroll across to the mountains with the clock dial, then press the Disp. button to turn date prinitng on and off.

I had exactly the same problem. I followed the directions to reset the clock. That is the cooking button and finish cooking button. They look like a caserole dish and a casserole dish with a cross through it. Hold them down at the same time and the + and - button to advance the time. Be aware I had to try this a few times before it worked. Hope this helps, Dean

Your range is stuck in SABBATH mode. You should be able to press and hold the clock button for 5 seconds to reset.

Not 100% sure about this model, but most have another battery in the camera for the clock functions. That battery could be low.
Try looking in the manual for the clock battery and pull that and replace it. See if that helps.

When you are in STANDBY mode hold the menu button for a few seconds and a special menu should pop up. In this menu you should be able to set the clock, turn off or on the beep, and take your unit out of demo mode. Good luck.
-Andrew Hawkins

error E:91:01
Reset the setting,on the clock set menu turn off the camera then remove the memory card and open the camera now reset the settings now you will get back your flash

Is it a switch or a dial? have you tried new batteries?have you removed them and let the camera sit with the batteries out over night? The button or mode switch could be bad.