My 1995 yukon wont start because of alarm how do i fix this

Jessica, Are you saying it will not crank over or cranks over - engine will not run?

Master Tech Lee

You can try inserting the key into the ignition, turning it to the run position (without trying to start it), and switch the valet switch on. Turn the ignition off and try to start the SUV. If that doesn't work the remote will need to be fixed. Either replace the battery or have the remote replaced. If the problem is within the alarm control module. you may need to have it removed or replaced. The system can not be bypassed. If you have other questions, please feel free to write back. Good luck.

Here is a useful link. Go to it, and look for the text, "Disconnect the battery" ... Read the steps to solve your problem!

www.justanswer.com/vw-volkswagon/1y9u8-reset-anti-theft-alarm-system-1995-vw-golf.html

Maybe by disconnectting your battery and reconnectting, you might be able to reset system.

Check for "Ignition crank sensors" GMC's are well known for water on these sensors and eating them up causing "no start" Hope this helps

change battery in your remote.

Start with checking fuses,try lights on &off a few times,it may be in light switch also try steering wheel tilt see if any change ..please keep us posted, let us know, if you need any further assistance please feel free to ask. Thank You...

fuel pump is faulty

First try to reset alarm by inserting key in drivers door lock and lock and unlock-if this does not work try tail lock as well.

i have a 1995 gmc yukon and when the motor was cold she start with no problem and run greatr when the motor get to temp and you shut it off it would start i tryed clean contact on the starter and that didntr work i tryed the battry cables that didnt work i was told tht it may be the oil sending unit i changed that and the problem went a way not say that your problem but look at the oil gauge see what it is doing when starting and then take it from there good luck hope this helps .....................