Hello
I have changed the tonr in the Sharp copier AR-5127 and get a error code "call for service H2-00" can somebody tell me what or haw do I reset this error code?
same error code with SHarp 1661cs.
Sharp Fuser
H2-0 Fusing unit
temperature error
H4-0 The fusing unit doesn't heat up.
***ALWAYS DISCONNECT POWER WHEN WORKING
ON MACHINE***
You have to reset fuser errors with simulation 14.
Push P * C * then 14 then Start (the button you use to make copies)
and it should reset the code. If not then replace the fuser.
SM
5-1 should turn the lamp on. If lamp blinks on and off it is the
thermistor, if it does not it is the lamp, but check the contacts on
the lamp/fuser -- they have been known to erode.
Also check thermal fuse, if defective
replace.
Help please
i forgot operator code what can i do to reset it
sharp ar- 5127
[email protected]
# --> interrupt --> clear --> interrupt
14 --> start
SOURCE: Sharp AR-5127 H2-00 code reset
it is a heater code. The thermostat has blown and resetting the code could cause a fire, but it probably won't do anything, the part will need to be replaced
12,519 views
Usually answered in minutes!
Sharp AR-M207 code H2-00 ,
h2 error
Code to clear H2-00 error on sharp AR5618D
×