My machine doesnt spin and is loaded with water
Possible there is no power switched from the controller unit , You need to use a meter to check the output to the motor or else the timer panel is faulty. Also If there is power and the motor does not spin then it can be fault in the motor or the capacitor or FRICTION on the drive.
SOURCE: Hotpoint WMA50p won't spin
Had same problem today with our machine. Brushes looked OK (although one appeared a little shorter than the other).
After removing and re-fitting the brushes, motor worked fine - suggesting that it was the brushes afterall.
Now looking for replacement brushes
SOURCE: Hotpoint Aquarius WF000 - water problems.
have u tryed to clean the fillter at the back of he machine
SOURCE: Hotpoint WMA11
If the motor is not getting power when it is called for spin. Then check the computer and the timer. Also check the balance sensor
SOURCE: hotpoint wt960 machine does not drain the water
Your drain pump is out. Usually attached to your motor and operates when the drain cycle is engaged. It's usally a 20 dollar piece. good luck.
does not Pump or Spin then checkout this tip... not draining and or not spinning41 views
Usually answered in minutes!
×