I have a Hitachi Wide screen model # 57G500A / manufactured in October 2003 serial # V3J003771
The screen went blurry. the colors seem to run together, and the top of the picture sags. Its like watching a 3D movie without wearing the glasses. Of course I can't find the oweners manual, and I do not have the Hitachi remote that came with the TV any longer.
can you help.
picture is blurry after being on for a couple of hours it clears up a little but not completlypicture is blurry after being on for a couple of hours it clears up a little but not completly
You can't post conmments that contain an email address.
Remove front panel and check the 6 control knobs adjust the intensity of each color as well as the focus of the picture with those colors.be sure to mark the knobs so you can return them to there original position if the set shuts off. Good luck
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Tv have a problems known as a convergence problems,it dead.Tv have colors lines R,G,B mis alignments,have colors shadow pictures or 3D pictures look alike?Yes,the tv convergence board have 2 dead convergence ICS and some or all of it resistors too.These parts must be replaced on the tv convergence board to solved the tv convergence picture problems.The shop,will cost u $300-350 for parts and labors.
Sounds like the convergence board, try replacing the STK voltage regulators and any resistors that may burned or discolored. This problem is causing the power supply to shut down probably.
I know these models came out around 2001, and I'm afraid that the problem sounds like it is related to the bulb going bad.
This article outlines how many TVs from around the turn of the century have had similar problems to yours.
I know bulb replacement is an option. You may want to call around to TV repair shops and see what your options are. In the end, though, it may be time to start saving up for a new TV.
its the convergence problem in your tv.the ic needs replacement.to fix the problem.its worth getting it fixed.get it repaired.
the cost will be negligible.
what colors appear on those lines...
you need to take it to a rep shop your convergence outputs are bad...where are you located at?..are you access on yahoo messenger...I can direct you to your problem you can fix it yourself I will show you how pin point on web cam..step by step...email me my email addr is [email protected]
Picture int disappears leaving snow on screen
Resolder the Xtal in the tuner
No picture
Replace IC (TDA8385J)
Sound but no picture
Check the LOT cable for short circuit
picture is blurry after being on for a couple of hours it clears up a little but not completly
×