Is there a cold and a hot stem for 9h-1h/c - Danco Faucet Cartridge

Most of those have a quarter turn plastic pie section at the top of the stem. It reverses for right or left (cold or hot) faucets. Turn off the water supplies, remove the top of the faucet and handles, put the pie shaped sections on opposite sides, reinstall the handles and turn the water supplies back on.

you can set the clearances cold but the measurements will be .002" bigger to allow for valve stem length increase when hot
example --a setting of .012" hot will be .014" cold
Hot is best as the stems do not always expand uniformly so valves in one engine may expand more or less in another engine
always check the clearance when hot
B&S engines are noted for valve stem stretch for a period from new so a regular monitoring of the hot clearance is a good idea ( check say every 20 hours operation for the first few periods until the clearance remains steady)

If I am not mistaken, the stems are specific to hot or cold. They turn in opposite directions. Someone may have put a hot stem instead of cold when doing a prior repair.

Price Pfister 1-800-732-8238

With posi-temp cartridges, if one supply of water, hot or cold, is interrupted, the cartridge automatically restricts the flow of the other water source. This is to prevent you from getting scalded if the pressure on the cold side drops because of a toilet being flushed or any other uses of cold water. The cartridge will only allow cold water to flow through if there is hot water to balance it out. If you restore hot water to the faucet, it will operate properly.

try taking the handle off and moving just the stem till the right side has all cold and left side is all hot..this mite adjust the stem

Thae stem you got that said hot/cold were designed to fit old style cross handle faucets. So both hot and cold turned the same way. If the cold side you are replacing turns the opposite direction then you will need to get a cold stem. Danco does make them. Ask the retailer where you purchased the H/C stem. I hope this helps..

sounds like you have a single lever shower, in this case the valve stem which mixes the hot and cold has a clogged hot side , you'll need to remove and replace the cartridge or valve stem

Peace Friend,
ngafm At your service!

You said,you have a Maytag Dishwasher MDB6601AWW. It went through a normal wash and you loaded it and it now will not start. It flashes 1H, 2H, up to 9H. It has flashed 81.

With an error code the only way to find and to repair this is,
First unplug the washer and wait a few minutes then restart it like rebooting your computer when its acting strange!
If it corrects the problem, GREAT!


If not only a trained laundry tech can make the electronic diagnoses.
Like we used to be able to fix my own cars, but not today they need diagnostic equipment!


How old is the washer?

If the appliance is 10 years old or more you it may not be advisable to put good money into bad!
New appliances are so much more efficient today that they can save you a lot of money in energy!!!!
Water,Electric and detergent! And put money back in your pocket!
The new appliance will pay for itself in only a few years!


You will be fine
Bless You ngafm
PLEASE GIVE ME A GOOD RATING HERE AT FIXYA.COM BEFORE YOU SIGN OFF.