Need instructions for lamp unit part number TY-LA2004

Consult the owner manual or call Panasonic customer service for the method for this model.

If I see one I do not know, I also will Google the model number with "reset lamp timer" etc. if the Panasonic line is busy.

The lamp time reset will be or should be in the owner manual---Google the model number with keywords "lamp install" with the model number and the "manual" with the model number---Google can be a great help.

Their manual says:
"
After lamp replacement, you must reset the lamp
time. Refer to the instructions enclosed with the
lamp unit (Part No.: TY-LA2005).
After lamp replacement, you must reset the lamp
time. Refer to the instructions enclosed with the
lamp unit (Part No.: TY-LA2005)."

from:

http://www2.panasonic.com/consumer-electronics/support/Televisions/LCD-Projection-TVs/model.PT-50LC13

Here is a link to replacing the lamp and the instructions for resetting the timer.

I hope that this helps you.
asnowman

http://911phone.net/Panasonic_TY-LA1000_Instruction_Manual%5B2%5D.pdf

Hold VOL - on the TV then aim the remote at the TV (watch so that your arm doesn't block the remote signal and press PIP or the SPLIT button. Do this together for at least 5 second. I hope this helps.

hello

Hold the Vol down button on the TV and the Split button on the REMOTE for five seconds, -or- Press the Volume button on the TV while pressing hte SPLIT button on the Remote Control for five seconds

It will NOT work if you try to do it both from your remote!

regards
shaun

press volume down on tv and pip or split on remote

Try the following:
If you need to get into the service menu, you can do so by following these directions:
With power on, hold down VOL minus button on projection display and hold down the PIP or SPLIT button (try both) on the remote simultaneously for more than 5 seconds.
You can also click here to get more instructions if the above do not work. See post # 4.

hi...

Panasonic lamp timer reset procedure

1. Press the power button to turn the unit on.
2. There are 3 choices for this step, depending on the housing part number:

A. TY-LA1000, TY-LA1500 or TY-LA2005 While pressing the VOL- button on the projection display, hold down the PIP or SPLIT button on the remote control at the same time for more than 5 seconds.

B. TY-LA1001 or TY-LA2006 While pressing the VOL- button on the projection display, hold down the number 0 button on the remote control at the same time for more than 5 seconds.

C. TY-LA2004 While pressing the VOL- button on the projection display, hold down the MUTE button on the remote control at the same time for more than 5 seconds.

3A. When the reset procedure is complete the the following screen will appear: LAMP TIME WAS RESET TO 0 (this screen may be different from the actual screen)

OR

3B. The POWER and LAMP LED's on the front of the unit will flash for 5 seconds. (TY-LA2006)

When the lamp time reset is finished, the LAMP indicator goes out. It may be necessary to attempt the procedure several times.

Hi Mac

Yes you can just take out the old lamp and install the new one in your existing lamp bracket. Simply unscrew , replace and screw back in.