Were can i find evap canister on 2001 mitsubishi galant

try this link
https://www.justanswer.com/car/3cb85-2001-mitsubishi-galant-immobolizwe-e-c-u-located.html

Location and information

https://www.justanswer.com/mitsubishi/7khod-mitsubishi-galant-2003-car-showing-p0441.html

The purge valve is located in the vacuum line between the fuel vapor containment canister and the intake manifold.

Mitsubishi Galant Purge Valve Replacement Cost Estimate

https://www.google.com/search?safe=off&rlz=1C1QJDB_enCA643CA644&sxsrf=ALeKk03mmyVCEHrQQIm9xoiMRqeAooKTvg%3A1612984487148&ei=pzAkYNvBCOWi_QbLr5XYDQ&q=03+mitsubishi+gallant+purge+valve+location

..

the causes for the small leak are listed as
hose connections --intake leak--- EVAP canister--- EVAP canister purge valve
check hoses for small cracks ( old hoses) or replace the purge valve

Take it in to a Mitsubishi) Dealer, To have it check out, Before it damages more stuff on the car,

its in the rear of the car near the fuel tank

code p 442 refers to evaporative emission (EVAP) system---small leak detected
it also refers to large leak detected --fuel cap off/loose === causes hose/connection,-- intake leak--EVAP canister---EVAP canister purge valve --mechanical fault --- EVAP pressure sensor

A code P0300 may mean that one or more of the following has happened:

• Faulty spark plugs or wires
• Faulty coil (pack)
• Faulty oxygen sensor(s)
• Faulty fuel injector(s)
• Burned exhaust valve
• Faulty catalytic converter(s)
• Stuck/blocked EGR valve / passages
• Faulty camshaft position sensor
• A code P0441 could mean one or more of the following has happened:
  
  • Bad vacuum switch
  • Broken or damaged EVAP line or canister
  • Open in PCM purge command circuit
  • Open or short in Voltage feed circuit to Purge Solenoid
  • Faulty purge solenoid
  • Restriction in EVAP solenoid, line or canister
  • Corrosion or resistance in purge connector
  • Bad PCM
  Defective computer

The EVAP service port is located in the EVAP purge pipe between the EVAP purge solenoid and the EVAP canister. The service port is identified by a green colored cap.



Fig. Showing location of (1) Evaporative Emissions (EVAP) Canister Purge Solenoid and (2) Exhaust Gas Recirculation (EGR) Valve




Fig. EVAP Purge valve solenoid (3) mounting bolt (2) and insulator (1) on 2000-2005 4.8L, 5.3L, 6.0L Engines

Hope this help (remember rated the post).

can you tell me where the fuel filter is located on a 01 mitsubishi galant?

Its located in the air filter housing....The volume air flow sensor also incorporates the barometric pressure sensor and the air intake sensor....If you are replacing either of these sensors replace the volume airflow sensor.......