Slyvania vcr keeps shuting off - Panasonic PV-V4022 VHS VCR

try all of these: 0456, 0458, 456, 458,002, 021, 022, 026, 062, 063, 065, 124

New 3 digit codes for DVD VCR DVR SAT TV VCR TV DVD DVR CABLE and DVR...

Wow - lots of info needed about your tv for a good answer there. But I can assume you only have a cable TV hookup on the back of your TV - and dont have a RCA input. So I will go on that. I had an old TV and had just this situation... I used my VCR to interface the DVD player for me.

So I ran the DVD player output to my VCR ( that had the typical RCA cables ) - Vidieo - Right channel- left channel - and then ran the VCR output COAX ( standard cable TV cable ) from my VCR to my old TV. once I selected channel 3 or 4 on my tv, I could see my VCR and my VCR would send me the DVD output, if I set the VCR to do that. Now I could record a DVD onto VHS ( for my personal use only of course ) good luck...

A VCR / DVD player is not a recorder. If it is a recorder you need to advise what input and output ports you have on each of the devices that you wish to connect, then the connection would be from the cable box thro' the recorder and into the TV.

Hello
The tape film has been coiled with its VCR mechanism parts and prevents the mechanism to shut OFF properly. This situation will be sensed by the main system control IC of your TV and it will shut the whole system OFF. That is happening now. To rectfy this, you have to open the unit and take out all the coiled tape film from the mechanism. In fact, the set should be deassembled as a whole. If you hav enough tools to do it, you can do it by yoursef. There is no components to be replaced. Only remove this coilde film from the mechanism OK.

GE

Manual code entry

1.Turn on your television or other electronic component that you want to program the remote control for.

2.Hold down the "Code Search" or "Setup" button until the LED indicator light turns on.

3.Hit the button for the component that you are programming (TV, DVD, VCR, etc.). The LED light should flicker and stay on.

4.Enter the 3-digit or 4-digit code that corresponds to the TV or device that you're operating.The LED light should go off if the code is valid, but will flash if it is not. Try other codes you have.

5.Try turning the television or other programmed component off to ensure that the remote works properly, once the light has gone off.


Auto configuration


1.Turn on your television or other electronic component that you want to program the remote control for.

2.Hold down the "Code Search" or "Setup" button until the LED indicator light turns on.

3.Hit the button for the component that you are programming (TV, DVD, VCR, etc.). The LED light should flicker and stay on.

4. Press and release the "Power" until the television or other component turns off while waiting at least 2 seconds between each press.

5.Press "Enter" or "Save" once the remote has effectively turned the power off. The LED light will shut off and the remote will now operate the device.


You can get your codes from below website

http://www.jascoproducts.com/support/universal-remote-codes.asp

Thanx

just go to a technician to fix your tv. maybe the button defective

Get new batteries for remote and go to web site for manual download. Or google for it.

if you do not have cable, fios or directv you will need the converter box

i have a nenith remote but lost codes and i have a vcr /tv combo unit tashiba what are the codes ?

I have the exact same problem but have not been able to fix it. I'd love to know if you came up with a solution.