Reebok tr2 incline wont work, back of machine starts to rise when you prees the incline up button

check and test safety [kill ] switch- circuit - motor

go please to www.fitnessrepairparts.com and get it.

God bless you

see the diagram attached and fix it. God bless you

1) readjust the speed sensor, clean it and tight the wires connector well
2) see the block diagram.
3) RUN the software calibration for diagnose, troubleshooting , fix it
4) lube the gear and shift elevation motor.
5) adjust the POT, a little and see if you have a better improve.
6) see the diagram, and proceed
God bless you

1) See the diagrams+block attached:
and proceed according. otherwise, you must call some service tech. To due the problem with wiring diagram.God bless you

Dear Sir:

You need LUBE the machine according with instruction manual for maintenance. if you do not have download free www.fitness.manualsonline.com or www.iconservice.com
The friction is enough by lack of lube, shut down the machine for protecting the electronic system.

Test the main motor ,drive belt,

After that RUN the software calibration for diagnose, troubleshooting and fix it.

sincerely. God bless you

Let me know if you find a solution. I am having the same problem and cant figure it out. It turns on and will start but none of the other buttons work. Its so frustrating.

With the key in the console, press one of the incline buttons. While the incline is changing, remove the key. After a few seconds reinsert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. Thi will recalibrate the incline system.

hey had the same prob. unplug and plug in again... worked for me