Blinking Light with no cartridge problems

Hi

The power light is blinking because one of your cartridges are bad. Hence need replacement. Try with the black cartridge as normally this goes bad.

Hi
this problem has many reasons :
- no paper or error in paper feed sensor.
- jammed paper in printer thats prevent it continue.
- try to disconnect usb cable and if its stop lighting reinstall the driver
- else you must search about hardware errors

Blinking 5 times: black cartrifge error (not recognized), blinking 7 times : colour cartridge error. See status monitor for detail. if ink running out message appear, just press ink button 30 second for releasing ink counter.

The Power light () might blink (flash) or be off. A blinking Power light indicates thatthe product requires maintenance, or is in an error state.

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c00859305&tmp_task=solveCategory&lc=en&dlc=en&cc=us&product=2510644#N221....

Check this link on how to resolve these problems

1. there is document in the queue but paper is out
2. Cartridge problem (remove and insert again)
3. Communication error
4. Cover is open

it is problem printer cartridge change it then solve it

ip3300 printer given error message 5100

Hi, Based on your post/description, the Siemens AP/Router is at fault. This could have been brought about by lightning, power surge, plain hardware failure or system/software error. The red status light - on indicates an error (on the firmware)(blinking during start-up or when firmware is being downloaded/updated); WAN light blinking green - data transmission to/from your ISP (it is also possible that the router is trying to download corrective software or firmware update). Suggest you let it run for sometime just in case it is really downloading/upgrading firmware. If full reset of the router doesn't correct the problem, you may have to replace the unit. Good luck and kind regards.