Flashing H20 When i start a cycle the display flashes with H20 and doesn't appear to be filling with water. the machine is a hotpoint aquatltis aqxxf149pm

The machine does not fill with water or 'H20' flashes in the display.
The water inlet hose is kinked. • The water inlet hose is not connected to the water supply. • The water pressure is too low. • The water tap has not been turned on to allow water to flow into the machine. • There is no water supply to the house. • The inlet valve filter is blocked. • The START/PAUSE button has not been pressed.

Faulty pressure switch machine thinks there is no water in the machine.

Check to make sure that the water valves are open and water is getting to the machine.

Hi from retired Englishman in SW France,
Indesit (Hotpoint, Ariston) Error code H20
(Quote)'If the machine is not in the demo mode and this error is displayed it means there is no water being supplied to the machine.
To cancel press and hold start/cancel then press again to cancel the drain and the machine should now be reset and display 'ON' as usual.'(unquote)

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C.

• H20 - Not fillings. Check tap, hose and inlet valves

• If you have proper water pressure the your water inlet valve on the machine is bad and needs replacing.

i have hotpoint aqualtis, it washes & empties but then starts flashing when ready to rinse. any suggestions?

H20 is indicating a problem with the water supply.
Check tap/s are turned on fully, no restriction in hose/s, and make sure that there is sufficient water pressure.
Another possibility is that the inlet valve/s are faulty inside the washer.
Please rate my solution.
Thanks.

H20 is a fill fault. check water taps are turned on, inlet hoses are not kinked. if ok then a possible fault with the inlet valve(s).

h20 code indicates that the appliance is not filling at all or filling to slow,check pipes are not kinked and taps are open correctly

H20 is indicating that you have no water coming in.
Check water is turned on,check hose(s) are not kinked, and finally check inlet valve.
If you are not sure if there is water to m/c, turn the tap off, disconnect the hose(s), and hold over sink and turn tap back on, water should come out, if it does not, then there is a prob with the supply.
Plz rate my solution.
Thanks.

hi sounds like a faulty fill valve easy fix