TV stuck in Aux mode, I don't have original remove

Sorry u can't fix this zoomming mode problems without the tv original remote.This tv zoomming mode function it is have it only on the tv original remote function only no where else.Try website like Remotes.com to buy the tv original remote to use.

Hello
Your sanyo TV has no menu button on its front panel control. Without its original remote, it is immpossible to get ito its AUX. OK.

You can program a Comcast remote to work with the TV. Press the "TV" button on the Comcast remote. Then, hold down the "Setup" button until the red light blinks 3 times. Enter a 5 digit code:
These are the Durabrand codes: 10171 10463 10180 10178 11034
The 10171 code worked for my Durabrand DWT1905. Then use the TV/VCR button located beneath the "7" to switch inputs.

Your code is 750....... Program the remote control in TV mode and then in VCR **repeating the steps** (or AUX - press 1 before entering the DVD code) mode.

How to program your dish network remote for your tv:

1. Use the device’s buttons or its remote control to turn on thedevice.

2. Press and hold the mode button for the device you want the remote to control, for about three seconds. When all the other mode buttons light up, let go of the mode button - that mode button should now be flashing. For example, hold the TV mode button for a TV until all of the other mode buttons light. When you let go, the TV mode light will flash.

3. Only for the AUX mode, Use a number button to enter 1 for a second VCR or DVD player

4. Use the number buttons to enter one of the device codes that I have given you.

5. Only for Limited Mode, Press 1.

Limited Mode- allow you to only use the remote to Power, Mute, and adjust Volume on your tv.
You cannot change the tv channel when the remote is in limited mode. You can only power on your
VCR in limited mode
****Note: Skip this step if you do not want to use Limited Mode.****
________________________________________________________________

6. Press the POUND (#) button. If you entered the code correctly, the mode button flashes three times.

7. Press the blank POWER button to test if the code works for the device. If it does, the device should turn off.

8. Turn the device back on and try some other buttons to make sure they work. Sometimes, the blank POWER button works when other buttons don’t. If the code works for other buttons
** Stop Here**


Let me know if this helps..


If I have helped you, dont forget to rate!!!

We had this same problem, and this is what resolved it. Unplug the tv from the wall, wait a minute, plug it back up, and turn it on again with the "power" button. This worked for us (without a remote).

Try to disconnect power for at least one day.

good luck---------tomtaso

pusht the ANT button