I've put my Life Fitness F3 Advance folding treadmill together and when I switch it on the console give me an error message "Replace Switch". I havent used it at all - not even begun to calibrate. What's going on? Help!
It was the emergency tag that you attached to yourself when you run (in case you fall over - the belt then stops etc). i had not connected it properly
Dear Sir:
I will try to help you, please see the videos, and do the steps with patience and carefully:
You must need some basice tools, Screwdriver, Dvom(Digital voltmeter) Hexagonals+Solder Iron+flux
Before to do disconnect the power cord, avoid ANY ACCIDENT!
http://www.youtube.com/watch?v=N6Yg5S0WML8&NR=1
http://www.youtube.com/watch?v=yX_0vRPdMfU&feature=related
http://www.youtube.com/watch?v=KppD23xEl8U&feature=related
http://www.youtube.com/watch?v=E-q-uS4t6so
With this you can fix it.
If you need further assistance, please reach me.
Sincerely. God bless you.
E.CUADRA
MANAGUA, NICARAGUA.C.A.
4,320 views
Usually answered in minutes!
Dear All
I have the same problem just assembled my Life Fitness F3 and it says Replace Switch, but I have have not even attached the emergency tag?
Dan
Everything is working except the incline feature of the treadmill. When we attempt to do the initial incline calibration on the electronic console, it gives us an error message that incline calibration cannot be performed. We are also unable to adjust the incline manually.
×