Missing contact in Nortel 1120E

Options-->Hold-->pound key

See page 15.


https://www.florenceinc.com/docs/en/Vista350-e.pdf

The phone's configuration is likely corrupt and it will need to be reset to factory defaults and reprogrammed.

To stop the reboot cycle, try this:

- Connect the phone to POE (Power Over Ethernet) injector, but do not plug in a data cable into the injector.

- When the message "Cable Unplugged" appears on the screen, connect a data cable to the POE injector.

The phone should return to an online state.

It requires a router with IP phone options. Like Cisco 2800 Series Integrated Services Routers. They are more for offices and are very expensive, but shop around there may be something out there for the home by now.

The message waiting needs to be enabled on the PBX for that telephone. I hope this helps. If not please connect with me at: http://www.liveperson.com/nortel-guy/ for service and support.

open you 1120E IP phone and you will see a small power back inside. replace that power pack and it should be ok

I'm not familiar with this particular phone, but our Nortel system phones sometime act up. The trouble is almost always the cord or handset, especially if the phone is wall-mounted and the handset has taken a dive or two to the floor. On rare occasions we've had a phone go bad, but not often.

Try another cord first, then swap handsets with another phone if you can. That will probably solve the trouble.

http://www.umanitoba.ca/computing/ist/telecommunications/media/1110userguide.pdf

You need to configure your CS 1000 for Personal Directory / Redial List / Callers List through Element Manager. Instructions for doing this are in the IP Line Fundamentals NTP. You can download the NTP from www.nortel.com/support.

If your system is a Nortel Callpilot just log into your mailbox, then press 8, the first option "Record your name in the company directory" is what I think you're looking for.

Try to reset the bandwith of the phone by using the nortel software.