Brand new washer today and tried to run the first load. After about 15 minutes, I get the fault code 245.
Be sure it is not the motor control assembly. If you receive a fault code 245 at the time of the rinse cycle. Shut it off and restart it from the beginning as if you at starting a new load. If you receive a fault code 49. Unfortunately, it is the motor control assembly. $200. That was my problem.
The drain pump impeller is seized; you just need to turn it a bit and will work just fine afterwards.
1,471 views
Usually answered in minutes!
WL80T65CW1 Fault code 10, have just installed a new controller module
×