Display is dim

SOURCE: Dim LCD's on DCS Double Wall Oven

Had the same problem last week - called DCS (which automatically transferred me to Fischer-Paykel) and was able to order the part from them.  They knew exactly what it was, and shipped to me in CA from CA, it was less than $90.  Just installed it, and the new one works swell.  One suggestion - I drew with a Sharpie on one side of each of the three parts that plug into the board to help align the new one, and to install the wide ribbon cable (not really a cable, but you'll know what I mean), pull up on the two side pieces and the ribbon pulls right out.  Keep it up and slide the new one in and then push the black piece down.  That was the only part that took me a minute to figure out.

SOURCE: Built-in Double Oven - Display fading

I have the same problem with mine. Do you know what the approximate cost for the repair is?

SOURCE: DCS wall oven very dim display for settings

typical for gas filled displays. check other postings for same problem for correction. part cost is $92.

SOURCE: The display - clock and the oven temp. readout on

the display or readout need to replace

SOURCE: When setting the temperature of either oven, the

Hi

This seems to be an issue with the display going bad. Please check the ribbon cable to the display, confirm it is fixed firmly and not cut. If cable seems to be fine then unplug the oven for 1-2 hours and check, else you may need to replace the display. Hope this helps... Please post back if you need more information.
Daniel