I have a Canon DS126191 and it shows an error message everytime i try to take a picture. Here is the message: "Communication between camera and lens is faulty. Clean lens contact." Any ideas on how to fix this?
Have you tried cleaning the lens contacts, both on the back of the lens and in the mount on the camera body?
SOURCE: Error message communication between camera and lens is faulty
Your flex cable to the Iris is broken. Have a look at my gallery at http://www.pbase.com/barry_2718/efs1785mm I have the same symptoms. At 28 or 35mm it make work ok. try Av mode and f8 aperture to see if you get an err01 because the aperture does not move either. Sound like you may have been sold a dead lens I am afraid to say. There are lots of reports about this lens failing after 2 to 3 years of use.
SOURCE: when i try to take
This is a basic fix, but have you removed the lens from the camera body and reattached it all? Check all of the connections while you're in there. Hope this helps =]
SOURCE: I have the tamron 18-200
So, have you cleaned the contacts as you were advised? You do this by removing the lens and cleaning the contacts on the camera body and on the lens where they meet with a cotton swab lightly dampened with rubbing alcohol.
SOURCE: how to repair err 01 on canon 1000d "Communication
So, have you cleaned the contacts? Remove the lens and using a cotton swab lightly dampened with rubbing alcohol, clean the contacts on the lens and the camera body where they meet.
143 views
Usually answered in minutes!
×