Bosch 23 in. SHU33A Built-In Dishwasher Logo

Related Topics:

tony sole Posted on Jan 14, 2013

Bosch dishwasher keeps filling and overflows - Bosch 23 in. SHU33A Built-In Dishwasher

5 Related Answers

DENNIS MITCHELL

  • 1003 Answers
  • Posted on Jan 18, 2008

SOURCE: dishwasher fills with dirty water after finish

CHECK TIMER AND WATER OULET SOLENOID

Ad

Anonymous

  • 56 Answers
  • Posted on Jan 05, 2009

SOURCE: BOSCH dishwasher SHU5302UC12 water will not fill

was the safty tab on the inside of the units water receiver removed?

Anonymous

  • 1 Answer
  • Posted on Apr 20, 2009

SOURCE: Bosch SHU 4000 series dishwasher; Water keeps on filling

Follow-up: I was able to fix the problem on Bosch model # SHU 4002UC. Purchased water inlet valve (part number 425458) from Sears Parts Center. I required the Sears unit number from the original invoice as Sears computer system apparently cannot identify the Bosch model number. The valve is as described by meyerjr above; however it is located at the bottom front of the machine so could be replaced (not so easily) without removing the machine. Cost of part was $30.50 Cdn including tax.
lwou

Anonymous

  • 2 Answers
  • Posted on Jun 22, 2012

SOURCE: My Bosch dishwasher keeps back filling from the sink or garburator.. Is there a p-trap in it?

there is a p - trap sort of, your drain hose is meant to work as one, when properly installed the hose will have a hole drilled for it to come ththat is slightly higher than the drain of the sink

Anonymous

  • 9 Answers
  • Posted on Sep 19, 2012

SOURCE: dishwasher keeps running

Open up the door, get out the control unit. Pry open the unit's plastic case and look at the board. Burnt spot? If so, the heater circuit burnt out (happens a lot on Bosches) and the control is waiting for the water temp to rise, but of course it dosn't. Thus- long wash times.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Dishwasher starts to fill, then displays watertap error.

Not enough information to answer. Need manufacturer and model number before we can help.
0helpful
1answer

Water overflow then no water

It may be a sticking float switch. The float switch controls the level of water in the dishwasher and if it is sticking on or off it could cause them problems you have
part numbers 263834 and 263185.
Hope this helps
0helpful
1answer

Dishwasher keeps filling

1) test the inlet valve for defective or pen

2) test the overflow siwtch for open or defective see the diagram
God bless you
6_19_2012_9_37_46_am.gif6_19_2012_9_38_03_am.gif6_19_2012_9_38_24_am.gif
1helpful
1answer

Water keeps filling after shutting off machine. Overflows onto the floor. Please help!

Hello,
Most of the time the problem is just the opposite of yours and the dishwasher will not fill...
This tip is about the dishwasher not filling, but the problem is still the same, only your soleniod valve has dirt under the plunger and it will not shut off. This tip will help you find it and help you to replace it.

http://www.fixya.com/support/r4021363-dishwasher_trouble_no_water_entering

Heatman101
4helpful
1answer

Bosch dishwasher fills with water after cycle is completed

Sounds like you need a new water inlet valve. It's not shutting off completely, so water slowly enters the machine even while it isn't running.
0helpful
1answer
Not finding what you are looking for?

241 views

Ask a Question

Usually answered in minutes!

Top Bosch Dishwashers Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Bosch Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...