SAP change with no remote

Press MTS/SAP on the remote (under the number buttons) to go between the 3 options of STEREO or MONO or AUTO SAP. Not all channels will have SAP (secondary audio program). Selecting stereo should eliminate any secondary audio.

Look for a button on the remote that said "SAP"press that button to release this modes."SAP" mode useally a tranlation to spanish languages for tv out put audio for certain channels.

it is most likely the remote receiver inside the tv. you can verify this by using a universal remote. if you cant get it to work the receiver is bad.

Go into the menu on the TV and go to the far right under setup. Select "video label" then select "program". A menu will come up listing the 7 inputs. Make sure that the input you are using for your PS3 is not set to "skip". While you're there, set any of the other outputs you're not using to "skip". Your TV/Video button will only cycle through the ones that aren't skipped. Have Fun!

YOU ARE IN SAP MODE. IF THERE IS NO SECOND AUDIO PROGRAM ON THE STATION YOU ARE WATCHING YOU WILL GET NO AUDIO. SWITCH SAP TO STEREO OR MONO. SOME REMOTES HAVE A MTS BUTTON ON THEM.

SAP is short for "second audio program" and is a way to send a second audio track along with the main one. In many areas stations use SAP to provide Spanish or other language sound for movies and other programs. If you have SAP turned on you don't know it until you tune to a channel where it's being used, and then you hear the other sound. Just turn SAP off using the remote control or TV menu.

Hello maymet,

This sounds like the HV protection circuit is cutting off the TV due to a high current event in the set. This could be a problem in the High Voltage section of your TV (Horizontal output transistor, Integrated High Voltage Transformer, and y of the deflection components, and or the CRT in cases of shorts).

I would suggest that if you do not have a background in electronics, you should have an experienced TV technician troubleshoot and repair this problem.
This is due to the nature of the dangerous voltages that are present in the television.

I hope this helps,

Thank you,

Shuttle83

i need a rc gide

Sony usually has a button on remote....MTS maybe....push =
cycles....Main...SAP....Mono.....
SAP = second audio program...........................T.

posible solution is adjust the screen to low.also check the trimer if it is working.check the resistor in the heater line...weng