Hello,
To enter into the convergence service of your sony, follow the steps below;
- Press "Menu" on the remote control. Use the up- or down-arrow button to move the cursor to "Setup" and then press "Return."
- Use the up or down arrow to move the cursor to "Convergence" and press
"Return." This will bring up the convergence-adjustment screen.
- Press the up or down arrow to move the cursor to the line you want to
adjust (either vertical or horizontal for red and blue) and press
"Return."
- Press the up or down arrow again to move that line until it converges with the center green line and press "Return."
- Repeat to adjust the other lines until all three lines converge and are seen as a white cross.
- Press "Menu" to exit the convergence menu and return to the original screen.
You can as well follow these steps;
- Press the "Power" button to turn your TV on.
- Wait at least 30 minutes before you adjust the convergence in your
television. This allows your TV ample time to warm up before you make
the adjustment.
- Turn your TV to a cable channel or to an antenna channel with a picture
that you can see. A music channel with a static shot of music notes
isn't the kind of picture you need. Instead, look for a picture like
what you would see on a movie, sitcom or drama.
- Press the "Flash Focus" button located in the front panel on your TV.
You may need to open a hidden compartment on the front of your TV to
access this button. The convergence will repair itself automatically
after you hit this button. It may take several minutes.
Any of the two processes are detailed steps on how to enter your convergence service.
Take care
×