F-h is the problem magtag neptune front load

check door inter lock

Check on this link for tips: click reset Magtag

sounds like you have a door lock problem, maybe the wax motor is not working properly of the spin switch is bad. You may have a problem with the motor controller also. Kind of hard to tell you how to trouble shoot on internet, unless you just want to replace parts till it works, call for service.

Hi,
Here is a tip that I wrote about dryers and noises...

It will help you determine what is happening there...

Dryer Repair Squeaks, Grinding, Clicking and Knocking Noise


heatman101

Asker's Testimonial "That answer was very informative - thank you fortaking the time to educate me. " - teresa241964

If you want to DIY the issue Google "Sticky: Neptune TL Washer FAV6800AWW" you can get the Service Manual from that site to help you DIY the fix along with forum guidance.

I discuss the troubleshooting the Left Hand Lid Lock in that sticky.

I can't find my repair notes on this forum no Sticky and no Service Manual.......D*ick

two problems here,
your shaft seal is running on its last leg
the sound is unmistakeable and always described the same...
the water issue, you probably have a trickle leak through the cold water valve
the mixing valve is quite an easy repair, but I would have to say with all honesty, it probably time for a new machine
the hub seal is a tub replacment call
2 hrs of labor if hes good
and the tub runs around 500.00 dollars
sory for the bad news

your un-balance switch may be getting bad/loose,need part # AP4027385 by whirlpool

unplug the washer for 15 minutes then:plug it back in and, restart a few times in a different cycle canceling each time until the door opens. Do this only if the tub is not full of water if it is let me know and, i'll show you how to drain the washer first before we try to open the door.

u just have to take the screws out and flip everything around