Need to know what the blinking yellow wrench on the Pride Jazzy 614 HD controller means. This chair has been sitting up unused for 2 years after my father's death. We plugged the charger into the chair and when you disconnect the charger the controller lights are on but there is a yellow wrench light blinking and the chair will not move.
Your version has a Dynamic Controls model controller and joystick.
Unplug the charger and engage the motor/brake lever so the chair is no longer in free-wheel mode (con't push by hand)
Turn the chair off, wait 5 seconds, turn the chair back.
If chair still does not run and your wrench is flashing you have a problem. Count the wrench flashes - the flash count indicates the error detected. 3, 4, 5, and 6 flashes indicate and error with the motors.
3=Left motor fault
4=Right motor fault
5=Left brake fault (may not be engaged)
6=Right brake fault (may not be engaged)
Any other fault code usually means the electronics or wiring is bad and not worth fixing.
SOURCE: i need ajoystick control modgel for a pride go
This company has new and reconditioned Joysticks:
Link for NEW joysticks:
http://www.monsterscooterparts.com/newjoysticks.html
Link for Reconditoned joysticks:
http://www.monsterscooterparts.com/refurbished.html
Warranty page:
http://www.monsterscooterparts.com/privacypolicy.html#warranty
This seem to one of the few that will list online openly and nationally.
Kelly
SOURCE: dead and wont move cant charge but batties are ok
sounds like a dead battery on the unit. see if you can get it replace .
13,419 views
Usually answered in minutes!
Not sure that it is a joystick issue. The yellow blinking wrench blinks twice and stops repeatedly.
hi if you uk based i can repair them,, here's a guide ...https://www.pridemobility.com/pdf/troubl...
3 flashes what can i do
×