How do i remove the seat for clean on safety 1st walker

There's tabs on the underside of the walker that are holding the cloth seat in place. Slip the buckle through the slot. They go all the way around the walker seat.

Thank you Kelstar 69 & Christina for your explanations. Your words "do not twist the peg side" and "twist the SEAT until peg is turned and released" were just what I needed. I worked and worked at this until between you, it finally made sense. Appreciate it!

Instructions on cleaning are usually included in the car seat's manual. Follow those directions carefully. It is important not to damage the harness or remove the flame retardancy of the cover by washing incorrectly.
-- Marc

Hi

http://www.ehow.co.uk/how_7471658_instructions-sounds-lights-activity-walker.html

Thank you kelcstar69 for your explaination! I was really struggling to get it apart! Made it so much easier! Thanks again :)

sounds like you have a buckle failure....this is the removal procedure...

1. Remove the front seat.

1. Disconnect the front safety belt buckle electrical connector.

1. Remove the front safety belt buckle.

NOTE: The front safety belt buckle retaining bolt is part of the safety belt buckle and should not be separated.
Installation

1. To install, reverse the removal procedure

Remove the plastic ring by pushing each tab inward and pulling the top piece of the ring up. Find the buttonhole on the back of the seat and put it over the little knob. Then work the fabric around the outside of the ring, tucking it on the inside of the plastic tabs, all the way around. Then, with the talles tab at the back where the buttonhole is, line up the top half and pop it back on. The fit is very tight and the fabric will be held in place by the ring.

Hi,
If you follow this link to the instrucitons on the maclaren website, the instructions tell you how to remove clean and reinstall the seat. http://us.maclarenbaby.com/toddler-buggies/techno-xt?lang=en
If you have any trouble call maclaren customer service at 1-877-443 4622
hope that helps!
1 877 442 4622 [email protected]

If it's the new model then you need to follow this in reverse order for Cleaning the Quinny Buzz seats (comfort cushion and XL seat)
1. Open safety harness
2. Unfasten the shoulder belt snap and hook and remove the belt pad.
3. Loosen all snaps on the bottom of the seat
4. Loosen the Velcro straps on the bottom of the seat. Remove the belt buckle through the opening of the seat
5. Slide the cord of the seats out of the edges of the Quinny Buzz seat. Start with the foot section and work towards the head section
6. Pull the lap belt of the Quinny Buzz seat through the holes of the seats and remove the loops from the shoulder belts from the openings of the seat

Mine, I have to remove the base first and then you can remove the strap and move it to another slot, or to clean