DAP-1360 hard reset

I THINK you are asking about a D-LINK dap-1360 range extender IF so see THIS YOUTUBE:
How to Configure Link DAP 1360 Wireless Range Extender

Be SURE to see this:
dap 1360 range extender Google Search

And this one too...

DAP 1360 Configure as repeater
NOT in English but lots in life is not... You can STILL see his setup steps clearly!

Anthony

If you can't remember the password, follow these directions to reset the access point to factory default. You can then log in with a username of admin and a blank password.

DAP 1360 Wifi Access Point Hard Reset PCingredient

If you know the current password, just log in and change it on this page
http://www.support.dlink.com/emulators/dap1360/101/tools_admin.htm

This is the manual for this wireless access point from dlink.

http://www.dlink.com.br/sites/default/files/product_download/DAP-1360_A1_Manual_v1.00.pdf

The error message should not mention emulators, return it to where you bought it, as it sounds as if the firmware version is not correct.

Go to this link http://support.dlink.com/ProductInfo.aspx?m=DAP-1360 and download the user manual for your DAP-1360. Configure it in the WISP mode following the manuals instructions.

1- first distance between Dap-1360 from the router wifi Nilox should be max the signal length around 50 meter,
2- try to update the Dap-1360 software from the internet then test the network cable again and the electric cable..
hope it help ...

Access D-Link's support-site: ftp://ftp2.dlink.com/PRODUCTS/DAP-1360/

Choose 'REV. A' or 'REV. B' or 'REV.C'.

Download the instructions for your router.

You don't need to connect via ethernet. In your laptop set the IP address to 192.168.0.2. subnet 255.255.255.0
This will probably temporarily disconnect you from your internet but you can reset the IP address back later. It might be a good idea to write your current settings down for later.
Open your browser and enter dlinkap or 192.168.0.50
You will connect to the Dlink AP
follow the directions in the user guide found at the link below.
http://global.dlink.com.sg/site_support/DAP-1360/Manual/DAP-1360_Manual_v1.00.pdf

have you tried turning on and off the router and AP? it would scan again...it looks like you just need to recheck connections and powers...

Click the Windows 7 "Start" button.
Type 'CMD' into the search-box, and press ENTER.
Type 'IPCONFIG /ALL' and press ENTER.
Look for the IP-address of the "gateway" (or "DHCP-server").
Type that IP-address into your web-browser.

just make sure that you belong with in the same IP range.
default DAP-1360 IP is 192.168.0.50
username : admin password :
change your PC IP address to 192.168.0.xxx (e.g. 192.168.0.2)
from there you may choose wizard or manual configuration.
you may change your DAP-1360 IP add according to your network settings in the office and you must change you PC IP address with in the same range.