Wires: Red, Black, Blue, White/Blue, Green, White/Green, Brown, White/Brown. What wires is +/- for DC power connection?
Black is usually negative; red is usually positive the coloured wires with a corresponding wire with a stripe are usually speaker wires where the white striped wire is negative. please state the exact model you want a wiring diagram for to see if we can help more
Testimonial: "Many thanks for your help!"
Hello Daniel! Thank you for your reply. This is CCTV camera Pelco ICS300-CRV3A. That camera supports 24VAC or 12VDC. In manual of camera I see that I should use 12DC power connector. But I have not this connector, because I got the cameras from Ebay. And in whole internet I can't found a wire diagram for this model of Pelco cameras. Very strange that this information is not listed in manual.
Thanks for clarifying, i was on the wrong track altogether. You need to be very careful not to connect this unless you are using the specified power source. The camera data sheet states 12vdc or 24vac but it doesnt mean it will use either power source. It means they manufacture two cameras almost identical, you choose 12vdc or 24vac when ordering.
sorry, this is embarrassing, i have too many internet pages open and i read the wrong one, it is a dual voltage camera, and I appreciate you need the wiring harness for the 12v application. next post should have some useful information please stand by!
OK... for 12vdc Red is (+) black is (-). if you use 24vac it wont really matter which way round they are put. The camera should auto sense the power supply you give it and work automatically. The other wires are for video signal. this link might prove useful, and if all else fails contact pelco: http://www.pelco.com/sites/global/en/pro...
Hi Daniel! Thanks for useful information! Today I will try
Hi Daniel! The solution has been found! Yes, for ICS310 series the red/black is true. But.. For ICS300 series the BLACK is - and WHITE/BROWN is +. Thank you anyway for your help! Even integrated heater in camera starts good, the proof in attachment:) PS: in Siberia now -40C :)
×
SOURCE: Wiring Problems
You didn't cut the plastic connectors off the factory wiring, did you? One is gray and one black.... if not, just get to a stereo shop and buy a wiring kit for your car and all colors will match. They're about $10. If you DID..... well..... we have a LOT of work to do....
SOURCE: wiring diagram
Red: voltage source controlled by the ignition key Yellow: constant voltage source Black: ground Blue: power antenna activation wire (if equipped) Blue/white: amplifier activation wire (if equipped)
SOURCE: CDC-R304
red = 12 volts switched (ignition)
yellow = 12 volts constant
black = ground
blue = power antenna
blue/ white = amp turn on
purples = right rear
grays = right front
greens = left rear
whites = right front
black striped speaker wires are negative side
there is only one power wire i cant remember the color use a test light to figure it out...then you need to make a wire off the fuse box that turns on when the ignition is on
SOURCE: DEH-P80MP need wiring/color description
http://www.pioneerelectronics.com/pio/pe/images/portal/cit_11221/103539332INSTALLATION%20MANUAL%20DEH-P80MP.pdf
Installation guide for your model with wiring diagram.
Hope this helps.
212 views
Usually answered in minutes!
CCTV camera Pelco ICS300-CRV3A
×