Plug is not with the receiver need to replace or wire diagram so I can hook up so I can use it
Hi there,
Kenwood adapter looms are readily available from your local Auto Accessory store, of from Ebay.
These are a 'plug & play' solution (pre-wired), which eliminates the need to cut any of your existing vehicle's wiring.
Ideally, you want a single adapter loom with Kenwood plug on one end, with your vehicle's "factory" plug on the other (all common brands are available).
e.g. Kenwood ---> Ford; Kenwood ---> GM etc etc
Cheers,
SOURCE: wiring harness in back missing a couple of wires
If you could tell how many pins per row on the connector at back then I might be able to help you out.
SOURCE: Need to know how to wire plug to speakers and power
Users manual is located here;
http://inform3.kenwoodusa.com/manuals%5Ckdc5005.pdf
Best of Luck.
SOURCE: no sound.
The first thing you need to do is doublechecking all the new wirings, it sounds like a contact.
SOURCE: hooking up a kenwood mp235
Blue/White - Power Control/Motor Antenna Control Wire
Brown - TEL Mute Wire
Blue - ANT. Cont. (Not Used)
White/Black - Front Left Speaker -
White - Front Left Speaker +
Gray/Black - Front Right Speaker -
Gray - Front Right Speaker +
Green/Black - Rear Left Speaker -
Green - Rear Left Speaker +
Purple/Black - Rear Right Speaker -
Purple - Rear Right Speaker +
Red - Ignition Wire (Switched +)
Yellow - Battery Wire (Continuous +)
Black - Ground Wire -
Here is a copy of the User Manual:
http://www.masterspas.com/manuals_av/Kenwood_KDC-MP2035.pdf
I’m happy to help further over the phone at https://www.6ya.com/expert/jeremy_69f3cc28d95bf514
Testimonial: "Thanks."
SOURCE: i have a kenwood krc-12 cassette receiver to hook
it costs 12 bucks for the plug and wiring harness at wall mart for chryler/ jeep.with the wiring harness instructions are on or in the package.u will need the plug if you are useing the factory speakers and factory wiring in jeep for power.if not just copy the instructions off the package.it will give you all you need to know,just match them up.and you should be all set/MAKE SURE YOU RECHECK ALL WIRING 2 OR 3 TIMES BEFORE PLUGING IN.
252 views
Usually answered in minutes!
×