Wall W wheel won't work

Try disconnecting all of your HDMI cables and plugging the power cord of the TV into another wall outlet. If this resolves the issue, you may have had a small power surge from either your wall outlet or one of your source devices. It is recommended to connect your TV to a surge protector if you haven't done so already.

usually a "humming motor" indicates either a bad capacitor or a defective motor. With the power off try to spin the blower wheel...it should spin freely. If it is tight or wont spin and there are no obstructions stopping it (like an air filter sucked into blower or other debris) then the motor most likely is seized. If the blower wheel spins free then you may have a bad capacitor. Keep in mind, just because the blower spins easy doesn't mean the motor is good. I have had motors that are defective that dont seize up but most of the time the blower wheel will not spin free if the motor fails.

Hi ... did u get this fixed cos mine is the same hve to switch off on the wall?

I hate to tell you this as you are an electrician but often it is best to look for the simple solution. My Stanley IntelliSensor Pro was doing the same thing here is the answer:
CHANGE THE BATTERY

You do have drive and reverse,if you have park and neutral.It just the transmission cant transfer that power a new or rebuilt is the solution

This situation sometimes occurs when the batteries get overcharged. Use the phone for a day and then attempt to charge. If it still won't charge, remove the battery for about a minute. Then re-install the battery and attempt to charge. If that doesn't clear the problem, you may need to get a new battery.

Sounds like the receiver portion of your logic board has quit. The wall control is hardwired and doesn't use the receiver.

You've to replace the ac adapter, if it's brick doesn't get warm or LED does not glow on Power Jack on the laptop. offcourse, check with the wall different sockets

power jack can also be loose. so jiggle the cable to find out.

if notebook is getting power, you can remove the battery, ac adapter, hold and keeep pressing poer button for a minute, then, turn it on.

finally, you can take out hdd and ram, put them back again and turn on the laptop. hope it will help

Here are instructions to building castle 4866,

http://www.playmofriends.com/forum/index.php?topic=5897.45

Also if you are having problems getting the gate to connect to the walls here is the fix

The red circles indicate that there is no proper fitting...after close inspection and going through the instructions again, I found out that I need to place the nortwestern corner, green circled, at a different system -x hole line.....

try cleaning the cliff sensors under bumper