2gb sd card but available only 1gb

Yes. Connect one of the sd cards to a computer and drag the photo onto your desktop. Now connect the second card and drag the photo onto the second sd card so that both photos are on the same card. If you have a mac, the sd cards will appear on your desktop. If you are using windows, I believe it shows up under your start menu and then my computer (though to be honest, I haven't used a computer with Windows in a while).

Your 4GB card is actually an SDHC card, not an SD card. While SDHC cards will fit into SD slots, they are electronically incompatible and will not work. You need to use an SD (or MMC or xD or MS), 2GB and smaller.

have you tried formating your SD card to FAT32 format?

The Dimage Z3 accept SD cards up to 1GB (Minolta says 512 Mb, and sold it with 16Mb). This camera is 4MP , and uses less memory on card, therefore a 512MB card will be enough for it.

SanDisk Flash memory card - 512 MB SD Memory ...

from $13 - 20 stores

PNY Flash memory card - 512 MB SD Memory Card ...

from $3 - 2 stores

SanDisk SD Industrial Flash memory card - 512 ... from $14

Here 1 Gb, try at your risk, but they normally work:

1GB micro SD memory card for Konica Minolta ...

£6.90 - www.mobile-laden.co.uk

1GB Flash Memory Upgrade Card for Konica ... £3.44 - Memory Express

Here review: Steves Digicams - Minolta DiMAGE Z3 -

Hi 1123sun,

Copy your files off the card. Then Format the card and select FAT32 file system. After the format is done try the card again and see if you can copy more files to it.

Kingston Tech Support

Depends on the size of each file ( picture). If your shooting a large formate then it could ( that's all you can get on it.

It seems that it's not about the size of file or resolution of the photo!

I was given one of these yesterday. I copied my photos on to a 64mb SD card of unknown make. They display fine on my PC but on my Photo Frame I get the "no playable file" message. I tried changing file size etc but no good.

As a last resort I copied my same photos on to a 2GB SanDisk SD card and tried that. It works fine. So my guess is that these photo frames are picky on what SD card they'll accept.

A pity the manual doesn't tell you so!

this camera with firmware below 1.03 has a problem with 2gb cards , i recommend 1 gb cards ( i have tried many until now it never stopt working ..so yes go back to where you bought the card (not accidentaly switched the white write protect switch ?? )

Check the Sansa tutorials at http://www.sandisk.com/Retail/Default.aspx?CatID=1468
to make sure you have followed all the steps first.

In my experience, every mp3 player/photo frame/etc with a card reader has a MAXIMUM memory limit for the type of card that it can read. It is possible that the Sansa player can only read 2GB Micro SD cards or smaller - and thisi nformation may not have been available when they printed the manual. If you have followed all instructions, and it still will not read the card, try switching to a 2GB Micro SD card.

is your sd card > 2 gb?
only supports up to 2gb