Goes off after power on - Mitsubishi VS-60603 60" Rear Projection Television

the black goes to power switch the other side of power switch goes to limit switch (high ans low cut off or in usually 125 psig off 90 psig back on). The other side of switch goes to motor, the withe goes to motor the green is ground.

Check the wakeup settings on the printer. Some were shipped with sleep mode on, but all all wakeup events disabled.

Your television is in need of repair. Hard to tell what exactly needs to be repaired but when the power light blinks in that way then this is the TV's way to tell you it needs to be serviced.

power light comes on and then goes off

replace the logic board, not the power supply board. you can find logic board on ebay as low as $29...

The hdd red wire gooes to pin #1 the hdd white wire goes to pin #3 the power sw orange wire goes to pin #6 the power sw white wire goes to pin #8 The reset sw blue wire goes to pin #7 the reset sw white wire goes to pin #5 the power led green wire goes to pin #2 the power led white wire goes to pin #4.
Now the layout of the pins is the long row (5) pins are the odd number pins 9 being the odd one and 1 is the other end of the row. 2 through 8 start at the pin accross from 1 : : : : . I hope this helps you.

this sounds like a power source problem! also the flyback converter on the circut board could be bad!