But have what seems to be hot water on the warm water wash/cold rinse setting
Tip1. Make sure your cold water turnoff is turned on all the way off before you check water screen. It could be clogged with sediment located inside threaded cold water hose connection.If clogged scrape clean or replace screen.Reconnect cold water hose and turn cold water supply all the way on. Tip2. Electric water solenoid could be defective or simply have a loose wire on the plug of the solenoid or loose plug / wire on mode switch.
Testimonial: "That was the problem, thank you"
108 views
Usually answered in minutes!
I found the answer to my problem. The cold water pipe frooze. I warmed it up with the low setting on my heat gun aimmed at the elbow of the pipe just below basement ceiling level! I did this for four or five minutes every is back to normal. I also put insulation between the pipe and outside wall but open to the warm basement air.
×