Infrared reciever ice control - Whirlpool Freezers

Found the solution for my machine with exact same symotoms: the hard water had covered the infrared source and/or receiver. They are opposing black and transparent 3mm circles on the left and right wall when you look inside your icemakee. They are supposed to detect if ice cubes pile up so high that they fisrupt the direct liner of view between those 2 dots.
Just clean them with a wet acidic solution to clean of the hardness, e.g. use vinegar or lemon juice.
Worked for me.

Nuwave 20326 Pro Digital-Controlled Infrared Tabletop ...

www.amazon.com > ... > Slipcovers > Slipcover Sets

Amazon.com, Inc.Amazon.com - Nuwave 20326 Pro Digital-Controlled Infrared Tabletop Oven, Black by IBC - Hearthware, INC - ... by Ibc Hearthware ... or ventilation needed; dishwasher-safe parts, Extender ring, cooking rack, baking pan, manual, and recipes ...

Owner's Manual - Home Depot

www.homedepot.com/.../9999807b-2e22-42d5-8cea-1...

The Home DepotManufactured by Hearthware Home Products, Inc. .... turn off the power before removal, or if digital, push .... Directions for Nu-Wave Oven Manual Control Dials ...THE MANUFACTURER WARRANTS - The infrared cooking system includ-.

The ice thicknes control is located on the bottom left. it has a wire going
to it and ha a black rubber bottom. depending on the position it is secured.
will determine the ice thickness. loosen the two screws and push it higher
for smaller cubes and lower for bigger. If you are having problems with it.
There is the possibility it is dirty and sticking.

small white button on control board. press once to stop beeping. Very small but it is labeled and very hard to see.

dear sir/madam
please make sure first your freezer,s defrost mode selecter set on auto mode or it,s set on auto defrosting mode. if it.s or freezer making continuously ice in ice bin then defrosting control device or temperature controller is not working for repair it please contact to your maintenance personnel for replace it .i hope after that it will work properly.

hope answer the question
thank you
please vote!

The control panel is most likely at fault. They are all controlled by the panel. Very rare for all 3 devices to go faulty seperately

Take a 6 inch piece of 14 gauge insulated wire and strip one inch of insulation off both ends of the wire. Bend the wire into a U shape. Remove the plastic cover from the front of the ice maker.Locate the holes marked L and V. Insert the 2 stripped ends of wire into the L and V slots. If you get water,the ice maker is bad. If you do not get water,the water valve is bad.

The bin control shuts it off when the ice bin is full. Without a bin control it should keep making ice and never stop.

the LED's are optics they sense the level of the ice in the bucket on the door under the icemaker is 2 1/4" screws you can remove the IM and the white cover put a small jumper in the pins T and H this will cycle the IM the door and optices will need to be closed (or best to tape them so you can leave the door open the IM should cycle if nt check the power at the N and L pins see if you have 120vs then we can go from there

If you need answers and have not recieved results I will try to help, I see no one responded to your request because the manual and diagnostics info seems to only be sent to people that sell and purchase the machine. If you need help and want answers  you can call me at 864-812-1887 or e-mail me at [email protected]  your description of the problems could be many different possibilities. I want to know and help also. Thanks John Tripp