At CO LINE MODE I selected disa for a line, in code 500 I selected with AA and in code 501 I selected appropriate jack no, but when incoming calls not happens no beep and system s=act as normal mode.
SOURCE: I have attached this cordless
If you start with intercom dial tone, press 81 or 82. If you dial 9 you'll get line 2 before line 1 in normal programming, and if you dial a line that's busy with 8x access codes, you'll get a busy, even if the other line is free.
Of course, you could also RTFM and program the system to function with your TA-824 http://public.carl.airpost.net/Pana/TA-824/UG_TA_0823%5B1%5D.pdf
Starting on page 15 or so of the pdf, after you set up the keys, you'd press the > and 1 or 2 to get to lines 1 or 2 :-)
Carl
Testimonial: "Just fantastic! Both the solutions were tried and worked!! I can't thank you enough.Have a great week-end."
SOURCE: we have Panasonic KX-T7731 telephones
A 3x7 system with 7731 phones tends to show that you have a TA-624/824 series system. CID is delivered to the phones via a xxx93 card and programming. In a 624 it connects to the main board via a ribbon cable and is installed in the system cover. The 82493 cards plug into slots on the main board. Once, or if, the card is installed, it needs to be turned on via programming. At the very minimum, program 900 in system programming turns it on and there are other parameters that you can adjust in the 900's.
Carl
115 views
Usually answered in minutes!
×