Zanussi ls9 dishwasher

https://www.zanussi.co.uk/support/support-articles/laundry/washing-machines/washing-machine-does-not-drain-displays-error-message-e20-e21-or-c2-emits-2-beeps-2-flashes/

Tank temperature low.

Dado

Dado

Good Afternoon Paolo, thanks for your post!

I see that you need to reset your Electrolux dishwasher due to replacing relay and an error code. The best way to reset your dishwasher is to disconnect power from it for roughly ten minutes. I hope that this information is helpful to you. -Matt

C8 - During rinse phase boiler doesn't empty:

• Rinse pump not efficient.
• Rinse arms obstructed.

• Boiler level sensor out of order.

Dado

Hi

E10 means there is no water getting in to machine.
check water supply if ok then fault will be fill valve.

regards

for remove C8 error on zanussi LS14 you must press on/off and press cycle2 key and you get FAC press cycle2 key again 8 times and you get CFG enter on family of this paremeter pressing ifinity key go to parameter ALR and you get ALR= 1 change to ALR=0 AND FIX THE PROBLEM.

write to me if you need the manual.as for the soap the dishwasher uses only liquid professional soap and you must connect it inside the tank . there is also a blue pipe for the rinse aid detergent
let me know if you need anything else

You need to reset the computer on the bottom. Had the same problem with mine. The Blinking led means the heating element is bad and will not operate.

c3 means that the temperature of the water inside the tank is higher than 60 degrees celcious.may be you have already connect the dishwasher with to much hot water or the rele inside the pcb is stuck.
waiting for answer