FL code Won't start, makes a popping sound.

replace door latch (fl = faulty latch ) good luck APPLIANCES R EN

There is no sound to flooding &
there is no vapor lock in over 30
years, since all vehicles are fuel
injected & the fuel either continually
flows back to the tank or deadheads
to fuel rail & is used

You either have fuel pressure or
it is too low or not there or pump
drains down when turned off

You obviously need a good battery,spark
plugs & functioning ignition system (spark)

Will have to be tested to see what your missing

Could be you have a stored code if the electronics
are checked first.

You need to provide a vehicle,year,make,engine,etc
& some detail of any problems,plus any testing done

Won't Start --- won't get you an answer or a quess

check your battery,or not clean battery terminals,or starter motor solenoid.

Possibly a bad connection on the positive side coming from the battery or a weak ground. Check where the leads join the terminal clamps. Has the battery been verified as good? It doesn't take a lot of amps to run lights but it does to turn over the engine. Jump starting it does not require a fully charged battery.

you could just have dead cell in the battery which isn't getting enough amps to the starter,, have the battery LOAD checked,, that will tell you if the battery is actually good, just because it registers 12 volts isn't necessarily an indication that the required amps are present.

I have a Yamaha RX-V571 AV Receiver and the published codes don't work for my Comcast silver remote w/ Red OK button. Managed to make it work while living in MD. Now in FL, have new remote and don't remember how I made it work before. Would love some help. T Y

does the van stall going down the road or at idle? the won't change gears at 4000 rpm and the no start condition unless disconnect the negative cable sounds more like a computer problem. when the cable is diconnected the ECM and the TCM have to go thru a relearn process which can be some of your issues. have your mechanic do a quick learn on the trans module to see if it helps the shifting problem. the ECM on the other hand can throw out codes that can make you chase your tail and end up replacing every sensor and still have the smae problem. you may want to check for corrosion at the ECM connections.

hi, this is an obd2 trouble code table, can help you understand the code. and this tool connects this tool can solve your problem,hope help.

FL error - Flood condition

"FL" flashes if any overfill condition occurs. This condition occurs when excessive water in the tub causes the overfill switch to trip. The control must realize that the trip was due to an overfill condition instead of a suds lock condition in order for "FL" to be displayed.

With an overfill condition, the beeper repeats a warning every 10 seconds with no time out. The pump is cycled in drain mode for 30 seconds on, 30 seconds off until the overfill switch resets or power is discontinued to the unit. Press STOP/CANCEL to clear the display.

You coudl se this manual: Service_Manual_PDF

Hope this helps.