LG 37LG300-ZA , stand by mod no pic no sound ... fuse was damage than i replace it new but it was damage , than i find out in power ckt. Bord F11NM60N mosfet has been short i changed it with same number BUT MY LCD DOS NOT WORK . ONLY POWER LED LIGHTING BUT IT STAND BY MODE ALSO LED TWINKLING.... MAY I GET SOLUTION? PLease HELP ME ... i will be happy ... Thanks
SOURCE: LG RZ 37LZ55 37 in HDTV LCD Screen Dead
hi there, the lights indicate that you have no video signal. do some test. ty
SOURCE: LG LCD TV Standby Light Flashing Red Continuously
I have had this same problem twice in the past 3 months. So far both times I've been able to get it back after a week or two. I'm not sure what works, but unplugging and detaching the antenna and cable and waiting a few days seems to be the key. In both instances, I unplugged it for a few days then plugged it in for a few days and repeated the processes until I eventually got the steady red led. Both times prior to the red led the led would flash red then green and make a clickiing noise for several hours before I was able to get it working again.
SOURCE: My LG Colour tv model no- RF-21FA20KV
go in touch with LG customer service....they will help u with ur problem
SOURCE: no pic but sound
My experience is that the Z-sus board has blown! . this because a little power supply on the Y-sus board is defective. This power supply feeds the drivers for the Z-susboard. replacing the Z-susboard will result in a working tv but it will allso blow sooner or later if the little powersupply on ths Y-sus board isn't repaired first! this little pwer supply, supplies the +15 volts for the gate drivers of the Z-susboard and if you measure on those gate-drivers you'll see that the supply voltage has dropped considerably due to bad elco's on the little power supply on the Y-sus board.
Replace those bad elco's first before installing a new z-susboard!
100 views
Usually answered in minutes!
×