..Additionally there is ONLY ONE coaxial terminal. --And I don't understand whether that ONE goes out to the TV or whether it functions as a Line In from the Cable box. --But then why aren't there 2 (TWO) coaxial terminals? ,,,More importantly, why doesn't the co-axial cable from my DVR XFinity cable box fit into the SINGLE co-axial terminal on the Magnavox recorder?!!
Check the coaxial cable connector type. There are two kinds--one that look like the RCA connector that you can just push in.
The other kind has a nut that you have tighten over the coaxial cable connector on the DVD recorder.
Hi, Sundar--Yes, my coaxial cable is the screw-in kind both from the TV and the XFinity (Comcast) cable box. --But more to my point is that this screw-in cable, which worked fine with my Sony VCR/DVD, and also the same nut-and-screw coaxial cable from my TV terminal, DO NOT screw into the Magnavox coaxial terminal! Also, as I mentioned before, Magnavox has only 1 (ONE) coaxial point! --What do I do about the 2nd (second) coaxial cable ? Something--either the TV or the Cable box will remain disconnected!--Is there someone at the Support Center who can draw me a diagram or tell me why Magnavox has just ONE coaxial terminal? --Otherwise I cannot use this recorder.
Sorry--but this was not helpful! my coaxial cable is the screw-in kind both from the TV and the XFinity (Comcast) cable box. --Neither yhis screw-in cable, which worked fine with my Sony VCR/DVD, nor the same kind of nut-and-screw coaxial cable from my TV terminal, DO NOT screw into the SINGLE Magnavox coaxial terminal! As I mentioned before, Magnavox has only 1 (ONE) coaxial point! --So what do I do about the 2nd (second) coaxial cable ? Something--either the TV or the Cable box--will remain disconnected! --Is there someone at the Support Center who can draw me a diagram or tell me why Magnavox has just ONE coaxial terminal? --Otherwise I cannot use this recorder.
×
SOURCE: Magnavox ZV427MG9 DVD Recorder VCR Combo DVD tray
There is typically a small rubber belt or plastic gear that goes between the tray motor and the tray. Most modern units have the plastic gear. I would bet that it is missing a tooth or stripped its teeth or possibly fell off completely. You should be able to manually push the drawer in. To open it, there should be a small hole near the tray into which you can push a straightened-out paper clip.
Good luck!
SOURCE: I have a Magnavox ZV427MG9
The design of the combo does not support RF output from its internal tuner. You have to use audio video or s-video output to TV. Or you have to add an RF modulator from Philips to output RF channel 3/4 analog connection. Combo RF output is just pass through DTV antenna connection.
320 views
Usually answered in minutes!
×