Question about Ranger Radio Communications

1 Answer

My galaxy dx 55 hp is getting hot at right rear on am modulation causing modulation distortion

Geting hot after about 5 minutes modulation on am

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Ranger Master
  • 1,847 Answers

Does it do his on the other bands also? Check your heat sinks in the area to see if they are also hot.the hottest one is probably going to be the culprit .Now find out what is on the sink and back step from there until you find out why that sink is getting hot.

Posted on Feb 23, 2015

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 463 Answers

SOURCE: it powers up....no modulation ...output power..or

Sounds like the PLL may be toast. Either that, or someone has **** with the wrong potentiometers or tuning slugs in the radio, causing to to no longer resonate on the correct freqs.

Posted on Mar 02, 2009

Don Reiman

  • 773 Answers

SOURCE: refurbished dx 959 from galaxy no modulation? no transmitt?

If there is no transmit at all, it sounds like it wasn't fully refurbished. If it is just low modulation then just turn VR16 and VR14 all the way to the left.

If its not working at all, send it back. It hasn't been refurbished.

Posted on May 03, 2009

cbmod

  • 1 Answer

SOURCE: i want to get the most performance out of my

I don't see how you could get more swing than the M-80 modulator. That thing kicks ***!

Posted on Jan 15, 2011

anymhz

AnyMHz.com

  • 500 Answers

SOURCE: galaxy dx 66v off frequency

gal 66 check the 10kHz switch. or you may have a bad cap, or crystal,.. the 33hp2 check the am regulator transistor... is bad or shorted.

Posted on Jan 24, 2011

John Cunningham

  • 6771 Answers

SOURCE: after 5 minutes of tx power go down

You may have a bad RF Transistor which is tied to the CB chassis, since it takes several minutes to break down, it is a thermal issue "tough to nail down" probably easier just to change the part.

Posted on Mar 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Overheating when keying mike to talk


This is almost ALWAYS caused by a poor antenna connection forcing the radio to dissipate the heat generated when transmitting.
Look for an open connection from your PL-259 plug where it connects to your radio or a dead short to ground in your antenna cable.

Hope this helps
-Steve

Mar 01, 2015 | Galaxy Radios DX-33HP2 Mobile Amateur...

1 Answer

How big of a fuse should my dx 55 hp have


If your rig runs the rated wattage of 12 watts PEP on ssb then a 4 amp fuse is plenty. If you run 4 watts 2 amps. They sell the fuses in Radio Shack 5 for $2.

Feb 14, 2014 | Galaxy Radios DX55HP 10 Meter Radio

1 Answer

Tx rx


the problem you now have is probably going to cost you more money to fix than the radio is worth. Could be a quick simple fix or you could be at it for hours trying to fix it. you will need a scope, frequency counter,watt meter, modulation meter, signal generator, volt meter,distortion meter,and a service manual from
www.cbtricks.com

Jun 18, 2013 | Galaxy Radios DX-33HML 40-Channels Base CB...

1 Answer

Galaxy dx 959not getting out far


MAKE SURE ALL CONTROLS ARE SET RIGHT MODULATION FULLY TO RIGHT CLOCKWISE, R-F GAIN FULLY RIGHT CLOCKWISE. TRY TO GET YOUR MATCH A LITTLE BETTER

Feb 23, 2013 | Galaxy Radios DX 959 SSB CB Radio

1 Answer

My galaxy dx 55 hp is getting hot at right rear on am modulation causing modulation distortion


take it to a tech , if you have to ask then you are not able to work on it . It is definatly an internal problem.

Dec 01, 2012 | Ranger Radio Communications

1 Answer

Mirage 88.. RX okay TX distorted


try the original mic . If its still distorted then it,s a radio problem.

Mar 14, 2012 | Galaxy Radios DX- 88HL Base CB Radio

1 Answer

Color distortion in an Akai ( Cheaper model Rear Projection tv) I


Ur convergence is dead.Try Tv repair World.com.
Buy a whole convergence board replaced it.

Jan 01, 2010 | Akai PT4799HD Rear Projection Television

1 Answer

It powers up....no modulation ...output power..or receive....just static...galaxy dx 949...


Sounds like the PLL may be toast. Either that, or someone has **** with the wrong potentiometers or tuning slugs in the radio, causing to to no longer resonate on the correct freqs.

Mar 02, 2009 | Galaxy Radios DX-949 40-Channels Base CB...

Not finding what you are looking for?
Radio Communications Logo

Related Topics:

86 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ranger Radio Communications Experts

Mike Charette

Level 3 Expert

1847 Answers

normis101

Level 2 Expert

65 Answers

Robert McClure

Level 2 Expert

161 Answers

Are you a Ranger Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...