I have a Panasonic PT-50LC13..When I come home and turn the TV on..The power light Flashes GREEN as it supposed to, then after a couple of seconds in starts blinking ORANGE every 5 seconds. I have to press the Power button again 2, 3 times in order for power button to turn GREEN and TV to turn on. If TV has been working for couple of hours and I turn it OFF and then ON again it usually turns on without a problem. What is the problem? and can I fix it myself?? I'm a pretty handy guy. Thank you.. Please help
I'd be looking at voltage ratings for the three fans and the the blower fan located under the projector itself. Check the air filters there are two but hard to get to the one under the projector lense. Id say toss and replace they have alot of issues that's why panasonic quit making tvs
Lamp could be bad or its a power supply problem
SOURCE: Reset Time Problem on Panasonic TV (PT-50LC13)
Power on the set, listen for afaint buzzing sound as the set tries to fire up. If you do not here it then your lamp driver, or ballast is most likely faulty. Also make sure you have the door and all covers back in place and secure. And make sure you insatlled an orginal panasonic lamp because some generic will not work.
SOURCE: panasonic projection TV power blinks in orange 5 times every 5 seconds
did you ck the lamp, can you ck voltage to ballast should be around 300 volts
SOURCE: panasonic pt-50lc13 shutting off
i'm on my 3rd bulb in 5 yrs. i hate this tv. this time my bulb light didn't come on. instead the power light flashed green fast then went to red flashing after. i took out the bulb and it's blown!
SOURCE: panasonic model# PT-50LC13
It very well could be the ballast. I unfortunately have this tv and keep extra bulbs because they go out about once a year. Last time when I replaced the bulb the tv blinked and the red lamp light flashed like it does when the bulb is bad. Ballast repair kit fixed it up. This is certainly a design issue but you'll get no help from Panasonic. If tv comes on the goes out after a while, clean the fan filter.
422 views
Usually answered in minutes!
I've chenged lamps on this TV twice in 7 years. Usually when the lamp is bad, LED(LAMP) flashes and TV does not work. This time it's different (Lamp) LED is not flashing or lit red. Can it be because of the filters, can i clean them myself?
This lamp has been in there for about a year and a half.
×